[nsp] 7304 NPE-G100 won't boot 12.2(18)S2?

[Gert Doering]

Hi,

On Wed, Dec 24, 2003 at 10:24:54AM +1100, Andrew Fort wrote:
> Self decompressing the image : 
> ######################################################################################################################################## 
> [OK]
> 
> *** TLB (Load/Fetch) Exception ***
> Access address = 0x0
>   PC = 0x00000000, SP = 0x80007e10, RA = 0x00000000
>   Cause Reg = 0x00000008, Status Reg = 0x34408003
> 
> monitor: command "boot" aborted due to exception

I've seen something similar with 12.0(18)S "-p" image on a 7200.  The
"-is" image worked fine, and 12.0(18)S1 and S2 "-p" images worked fine
as well.  Tested on two different 7200s (7200/NPE-225 and 7200VXR/NPE-300),
same result.

I came to the conclusion that the image was mis-built, and didn't do
any further research about it.

> Anyone else see this?  I've tried -p- and -k91p- and they both show the 
> same circumstances.  12.2(18)S works, as does 20S.

Have you tried "-is" (if it is available)?

12.2S releases seem to be "somewhat interesting"...

gert

-- 
USENET is *not* the non-clickable part of WWW!
                                                           //www.muc.de/~gert/
Gert Doering - Munich, Germany                             gert at greenie.muc.de
fax: +49-89-35655025                        gert at net.informatik.tu-muenchen.de