[nsp] back to back serial connections

[Ajay Saini]

Thanks for replying. I tried giving clock source internal on 7200 but the only option I see under clock is rate
i am running IOS 12.2 (c7200-p-mz.122-4.T.bin)...

regards,
Aj
  ----- Original Message ----- 
  From: Duane de Witt 
  To: 'Ajay Saini' 
  Cc: 'cisco-nsp at puck.nether.net' 
  Sent: Friday, February 28, 2003 1:08 PM
  Subject: RE: [nsp] back to back serial connections


  If it is back to back you need to set your clock source on one side?



  Regards

  Duane

  -----Original Message-----
  From: Ajay Saini [mailto:sainiajay at hotmail.com] 
  Sent: Friday, February 28, 2003 2:07 PM
  To: cisco-nsp at puck.nether.net
  Subject: [nsp] back to back serial connections



  i have always used serial interfaces with frame-relay point to point connections but just tried the back to back serial connections with encapsulation hdlc between CISCO 7200 and Cisco 2500. I am getting the link status as up but the protocol is down. The configs are as follow:



  cisco7200:
  interface Serial1/2
   ip address 10.70.14.1 255.255.255.252
   ip directed-broadcast
   no ip mroute-cache
   no cdp enable




  cisco2500:
  interface Serial0
   ip address 10.70.14.2 255.255.255.252
   ip directed-broadcast
   no ip mroute-cache
   no cdp enable



  any suggestions regarding anything i am missing will be appreciated...i tried giving on 7200 interface the dce-terminal-timing-enable command but got the same result.



  thanks,
  Aj 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://puck.nether.net/pipermail/cisco-nsp/attachments/20030228/0f061a4f/attachment-0001.htm