[nsp] PPPoE over an IEEE 802.1Q VLAN

[Jason Lixfeld]

What about 12.2T?

Although  I haven't had time to dig in and figure out why ppp keeps  
failing it seems to be configurable in 12.2(13)T (on a 7204VXR).   
Although in my configuration I'm doing it over ISL and I haven't had a  
chance to dig through the feature matrix to see if it supports dot1q as  
well.

On Tuesday, July 15, 2003, at 2:02 PM, jlewis at lewis.org wrote:

> http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/ 
> products_feature_guide09186a0080080386.html
>
> I found out the hard way that this feature, present in late 12.1T, is  
> not
> in 12.2S.  Also, when going back to 12.1(5)T12, putting pppoe enable  
> back
> into the appropriate subinterface crashes the router with
>
> System returned to ROM by bus error at PC 0x0, address 0x0
>
> I did this twice in a row before shutting the fastE interface before
> entering pppoe enable.  That made the router able to accept the command
> without crashing.
>
> Anyway...PPPoE over an IEEE 802.1Q VLAN doesn't seem to be a searchable
> feature in go/fn.  So, are there plans to support this (or even just  
> PPPoE
> on regular fastE interfaces...it actually isn't supported at all in  
> 12.2S)
> in 12.2S at some point, or are we stuck with 12.1T on these routers?
>
> ----------------------------------------------------------------------
>  Jon Lewis *jlewis at lewis.org*|  I route
>  System Administrator        |  therefore you are
>  Atlantic Net                |
> _________ http://www.lewis.org/~jlewis/pgp for PGP public key_________
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/