[nsp] PPPoE authentication CISCO 3600 + RADIUS server.

[Ezequiel Carson]

What attributes is your radius responding in the Access-Response?

Have you tried adding Service-Type=Framed-Protocol etc..etc.

Zk

On Thu, 2003-03-06 at 07:11, Rafa Marín López wrote:
> Hello all.
> 
> I have built a test that consists of :
> 
> FreeBSD 4.7 <-----------> CISCO 3600 <---------->FreeRadius.
>                           pppoe
>                             ( ipv6cp)
> 
> My problem is FreeRadius authenticates to client (FreeBSD) and it says 
> OK but CISCO 3600 do not establish connection with FreeBSD 4.7 because 
> of  authentication failure :( . But I don't understand because 
> FreeRADIUS send and Access-Accept to the router.
> 
> My CISCO configuration  is :
> 
> aaa new-model
> !
> !
> aaa authentication login default none
> aaa authentication ppp default group radius
> aaa authorization network default group radius
> aaa session-id common
> .......
> 
> interface Virtual-Template1
>  no ip address
>  ipv6 enable
>  ipv6 mtu 1480
>  no ipv6 nd suppress-ra
> ppp authentication chap //IF THIS LINE IS DELETED AUTHENTICATION 
> INFORMATION IS NOT SENT TO RADIUS SERVER :(
> !
> 
> -- 
> ------------------------------------------------------
> Rafael Marin Lopez
> Faculty of Computer Science-University of Murcia
> 30071 Murcia - Spain
> Telf: +34968364644	e-mail: rafa at dif.um.es
> ------------------------------------------------------
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>