[nsp] VLAN settings on 2950s/2610s

[Tay Chee Yong]

I remember knowing about VLAN tagging on Ethernet ports, but not too sure which
IOS will support it.

And also is there any restrictions of this feature to any hardware platform, or
is it enabled for all IOS platform?

Would appreciate if any Cisco guy could enlighten us on this.

Thanks.

Cheeyong


On Sun, 11 May 2003, Sharan Harkisoon wrote:

: This feature was added to later versions of  IOS, so you can do VLAN tagging
: on 10meg ports.
:
: Sharan
:
: ----- Original Message -----
: From: "Pete Templin" <pete.templin at texlink.com>
: To: <security at cytanet.com.cy>; "Sharan Harkisoon" <sharan at sharktek.net>
: Cc: <cisco-nsp at puck.nether.net>
: Sent: Saturday, May 10, 2003 1:36 PM
: X-Scanned: By Symantec Anti-Virus Scan Engine
: Subject: Re: [nsp] VLAN settings on 2950s/2610s
:
:
: > 2610 routers have one Ethernet and zero Fast Ethernet interfaces.  Last I
: checked (which admittedly was a long time ago), Fast Ethernet was required
: for VLANs.
: >
: > Pete Templin
: > IP Network Engineer
: > TexLink Communications
: > (210) 892-4183
: > pete.templin at texlink.com
: >
: > -----Original Message-----
: > From: Security [mailto:security at cytanet.com.cy]
: > Sent: Saturday, May 10, 2003 1:48 PM
: > To: Sharan Harkisoon
: > Cc: cisco-nsp at puck.nether.net
: > Subject: Re: [nsp] VLAN settings on 2950s/2610s
: >
: > The use of the native command did not help. I used it on the subinterface
: > of the cisco2610 and also on the trunk port on the switch. The only way to
: > make trunking work was to configure two VLANs on the 2950 switch without
: > using VLAN1. I am thinking to proceed and upgrate the switch software
: > and/or the router IOS to see what will happen.
: >
: >
: > >This is correct, I've had this issue when switching from a 7206 to a
: 3620.
: > >I think the the 7206 didn't require "native" on the VLAN1 interface, and
: > >worked fine.  Could have been a firmware issue.
: > >
: > >Just make sure to add the "native" command on the end like Ryan
: suggested.
: > >
: > >interface FastEthernet4/0.1
: > > encapsulation dot1Q 1 native
: > >
: > >
: > >Sharan
: > >
: > >----- Original Message -----
: > >From: "Ryan O'Connell" <ryan at complicity.co.uk>
: > >To: <security at cytanet.com.cy>; <cisco-nsp at puck.nether.net>
: > >Sent: Friday, May 09, 2003 10:25 AM
: > >Subject: Re: [nsp] VLAN settings on 2950s/2610s
: > >
: > >
: > >> At 09/05/2003 16:12, Security wrote:
: > >> >I spend several hours working with catalyst2950 switch and a Cisco2610
: > >> >router trying to configure VLAN trunking using 802.1q. I Discover that
: > >when
: > >> >one of the VLANs is the default (VLAN1) trunking is not working. Using
: > >> >other vlans e.g vlan2 and Vlan3 trunking is working perfectly.
: > According
: > >to
: > >> >Cisco Documentation trunking should also work with VLAN1 as one of the
: > >> >VLANs.
: > >> >
: > >> >Can anyone advise? I am thinking of a bug on the software of the
: switch
: > >but
: > >> >your advice will be appreciated
: > >>
: > >> Make sure you have Native (default) VLANs set properly both sides -
: > >> switches have a default native VLAN and router don't. Anything in the
: > >> native VLAN doesn't get tagged when being sent out, so the router will
: > >drop
: > >> it when receiving it unless one subinterface has been marked "native".
: > >>
: > >>  From memory, by default on the 2950 the default native VLAN is 1 so
: you
: > >> need to make sure you use "encapsulation dot1q 1 native" on the 2610
: for
: > >> the appropriate subinterface. (This is from memory though, I may have
: it
: > >wrong)
: > >>
: > >> _______________________________________________
: > >> cisco-nsp mailing list  cisco-nsp at puck.nether.net
: > >> http://puck.nether.net/mailman/listinfo/cisco-nsp
: > >> archive at http://puck.nether.net/pipermail/cisco-nsp/
: > >>
: > >
: > >
: > >
: > _____________________________
: > CYTANET WebMail
: > http://webmail.cytanet.com.cy
: > _______________________________________________
: > cisco-nsp mailing list  cisco-nsp at puck.nether.net
: > http://puck.nether.net/mailman/listinfo/cisco-nsp
: > archive at http://puck.nether.net/pipermail/cisco-nsp/
: >
: > _______________________________________________
: > cisco-nsp mailing list  cisco-nsp at puck.nether.net
: > http://puck.nether.net/mailman/listinfo/cisco-nsp
: > archive at http://puck.nether.net/pipermail/cisco-nsp/
: >
:
: _______________________________________________
: cisco-nsp mailing list  cisco-nsp at puck.nether.net
: http://puck.nether.net/mailman/listinfo/cisco-nsp
: archive at http://puck.nether.net/pipermail/cisco-nsp/
: