[nsp] How to remove the config of a removed 6500 line card?

Stephen J. Wilcox steve at telecomplete.co.uk
Wed May 14 16:23:08 EDT 2003


Thinking along the same lines I wondered if its not like where you delete a vlan 
interface or subinterface and it shows it as a deleted interface with some 
config in memory until you reboot...

Steve

On Wed, 14 May 2003, Robert A. Hayden wrote:

> I don't consider this a "fix" but what happens if you reload the switch?
> Does the old config remain or does it finally go away?  More curious than
> suggesting it's how one for fix it.
> 
> On Wed, 14 May 2003, Stacy J. Brandenburg wrote:
> 
> > I have found that with the FlexWAN Module WS-X6182-2PA, if you remove
> > them from the chassis that you cannot remove the interface info or any
> > routes to the physical interface.  I always have to reinsert the module,
> > remove the needed lines, then remove it again.  Cisco has been unable to
> > tell me why this occurs, but has confirmed that it does occur.
> >
> > Write mem did not clear up my issues.
> >
> >
> >
> > sthaug at nethelp.no wrote:
> > >>So we removed a 6500 line card from a slot - but the running config
> > >>still has the entries for those interfaces.
> > >>
> > >>How to get rid of them, short of a reload?
> > >
> > >
> > > Doesn't a normal "write mem" get rid of them?
> > >
> > > Steinar Haug, Nethelp consulting, sthaug at nethelp.no
> > > _______________________________________________
> > > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > > http://puck.nether.net/mailman/listinfo/cisco-nsp
> > > archive at http://puck.nether.net/pipermail/cisco-nsp/
> >
> >
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 



More information about the cisco-nsp mailing list