[nsp] How to remove the config of a removed 6500 line card?

[Robert A. Hayden]

I don't consider this a "fix" but what happens if you reload the switch?
Does the old config remain or does it finally go away?  More curious than
suggesting it's how one for fix it.

On Wed, 14 May 2003, Stacy J. Brandenburg wrote:

> I have found that with the FlexWAN Module WS-X6182-2PA, if you remove
> them from the chassis that you cannot remove the interface info or any
> routes to the physical interface.  I always have to reinsert the module,
> remove the needed lines, then remove it again.  Cisco has been unable to
> tell me why this occurs, but has confirmed that it does occur.
>
> Write mem did not clear up my issues.
>
>
>
> sthaug at nethelp.no wrote:
> >>So we removed a 6500 line card from a slot - but the running config
> >>still has the entries for those interfaces.
> >>
> >>How to get rid of them, short of a reload?
> >
> >
> > Doesn't a normal "write mem" get rid of them?
> >
> > Steinar Haug, Nethelp consulting, sthaug at nethelp.no
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > http://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>