[nsp] NM-2w 2600 wont detect

[Brad Bonin]

Supported in the following:
12.0(7)XK, 12.1(1)T, 12.1(5)YB, 12.1(5)YD, 12.2(1), 12.2(2)T, 12.2(2)XT,
12.3(1)

12.0(7)XK was created from the 12.0T train, so that is why 12.0T didn't
work.  12.0(7)XK3 features were ported into 12.1(2)T, no 12.1(1)T (per
release notes).

I suggest you go to a mainline release if you can, such as the latest
12.2 release, I believe 12.2(16).  It all depends upon hw and sw
requirements though.

Good luck,

Brad

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Voll, Scott
Sent: Tuesday, May 20, 2003 6:08 PM
To: James hampton; cisco-nsp at puck.nether.net
Subject: RE: [nsp] NM-2w 2600 wont detect


Look for an ios upgrade.  Someone can correct me if I'm wrong, but I
believe that it's like a feature that only some IOSs have.  

--Scott

-----Original Message-----
From: James hampton [mailto:jamhampton at toast.net] 
Sent: Tuesday, May 20, 2003 2:53 PM
To: cisco-nsp at puck.nether.net
Subject: [nsp] NM-2w 2600 wont detect

I have a 2600 that wont detect aN NM-2w modual. It has IOS 12.0(7)T2,
the Cisco site says 12.0(7)XK is needed for NM-2w. Im not sure if
12.0(7)T2 is an earlier or later release than 12.0(7)XK. Should I
upgrade IOS or look for another problem?  Thanks

James
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/