[nsp] PRI Trunk Group

[John Tobias]

Lookup "dialer pool-member x" command under the PRI serial interface, and
dialer pool x" under the dialer interface.

John Tobias

-----Original Message-----
From: Andy Melton [mailto:andy at meltons.net] 
Sent: Thursday, May 29, 2003 1:17 PM
To: cisco-nsp at puck.nether.net
Subject: [nsp] PRI Trunk Group

Is it possible to create a trunk group, comprised of multiple PRI ports?
Essentially, I've got 4 PRIs going to the same switch, and rather than
create a dial-peer for each port, I'd rather bind the PRIs to form a
single logical group and transmit calls to that trunk group.  Via some
round-robin type routing scheme, the gateway (5350) would allocate DS0s
when needed.

Is that possible?  I see how to make trunk groups with analog
interfaces, but can I make a single logical PRI trunkgroup?


_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/