[nsp] AS5300 to DEX-600E ISDN PRI

[Vincent De Keyzer]

I think this might not be bad at all. The bearer cap problem could just be
that the AS5300 is not configured to accept "such" calls. 

For instance, when I place test calls from a PRI on a router, I can get to
call some mobile phones but not some others!... It has to be the right
combination of ISDN/voice/data etc., and both terminal equipments have to
agree on those.

Can you place outgoing calls? (try different mobile phones/ISDN lines/fixed
phones, etc.)

What does the 'sh isdn status' say for your Serial0?

Vincent


> I'm trying to connect an AS5300 to an Alcatel Megahub 600E.  
> The 600E can only communicate as DMS-250 or ANSI T1.607.  We 
> are using NFAS.
> 
> I have tried isdn switch-type primary-dms100, but on all 
> calls from the 600E to the gateway, my q.931 debug says:
> 
> "Nov  5 17:35:14.282: ISDN Se0:23 **ERROR**: call_incoming: 
> Received a call id 0x3D with a bad bearercap from 3103215708 
> on b channel 12 Nov  5 17:35:14.286: ISDN Se0:23 Q931: TX -> 
> RELEASE_COMP pd = 8  callref = 0x800C 
>         Cause i = 0x80BA - Bearer capability not available"
> 
> I'm not sure what bearercap it's talking about.  Has anyone 
> had success with ISDN PRI signaling between an AS5300 and 
> Alcatel/DEC DEX600?
> 
> Any feedback would be helpful.  Thanks.
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco> -nsp
> archive at 
> http://puck.nether.net/pipermail/cisco-nsp/
>