[nsp] Newbie Question: Wic-2t on 3640 running IOS 12.3

[Santa Klaus]

Hi,
 
I have a Cisco 3640 which i just bought from ebay. The router has 12.3 IOS loaded on it. 
I bought a WIC-2T from another person. Now the Wic-2T doesnt seem to be getting detected by the Router. Show diag gives the following:

        NM-2FE2W Port adapter, 2 ports (Could someone explain this and the next line pls. Is the Module itself at fault?)
        Port adapter is disabled
        Port adapter insertion time unknown
        EEPROM contents at hardware discovery:
        Hardware Revision        : 1.0
        Top Assy. Part Number    : 800-04797-01
        Board Revision           : E0
        Deviation Number         : 0-0
        Fab Version              : 04
        PCB Serial Number        : JAD06220LKQ
        RMA Test History         : 00
        RMA Number               : 0-0-0-0
        RMA History              : 00
        EEPROM format version 4
        EEPROM contents (hex):
          0x00: 04 FF 40 00 D8 41 01 00 C0 46 03 20 00 12 BD 01
          0x10: 42 45 30 80 00 00 00 00 02 04 C1 8B 4A 41 44 30
          0x20: 36 32 32 30 4C 4B 51 03 00 81 00 00 00 00 04 00
          0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
          
What might be the problem? I tried removing and reinserting the card, to no avail.
Is the card bad? Could I have the wrong IOS? Will it work with 12.2? I have 12.3 now, currently. The wic-2t compatability listing does not explicitly list 12.3, thats why Im asking. 
 
Just want to make sure that it isnt something other than just the card being a dud. 
Show interface displays the fastethernet0/0 and 0/1 interfaces but not the serials.
Thanks in advance.


---------------------------------
Do you Yahoo!?
Free Pop-Up Blocker - Get it now