[nsp] Newbie Question: Wic-2t on 3640 running IOS 12.3

[Bruce Pinsky]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Santa Klaus wrote:

| Hi,
|
| I have a Cisco 3640 which i just bought from ebay. The router has 12.3
IOS loaded on it.
| I bought a WIC-2T from another person. Now the Wic-2T doesnt seem to be
getting detected by the Router. Show diag gives the following:
|
|         NM-2FE2W Port adapter, 2 ports (Could someone explain this and
the next line pls. Is the Module itself at fault?)
|         Port adapter is disabled
|         Port adapter insertion time unknown
|         EEPROM contents at hardware discovery:
|         Hardware Revision        : 1.0
|         Top Assy. Part Number    : 800-04797-01
|         Board Revision           : E0
|         Deviation Number         : 0-0
|         Fab Version              : 04
|         PCB Serial Number        : JAD06220LKQ
|         RMA Test History         : 00
|         RMA Number               : 0-0-0-0
|         RMA History              : 00
|         EEPROM format version 4
|         EEPROM contents (hex):
|           0x00: 04 FF 40 00 D8 41 01 00 C0 46 03 20 00 12 BD 01
|           0x10: 42 45 30 80 00 00 00 00 02 04 C1 8B 4A 41 44 30
|           0x20: 36 32 32 30 4C 4B 51 03 00 81 00 00 00 00 04 00
|           0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
|
| What might be the problem? I tried removing and reinserting the card, to
no avail.
| Is the card bad? Could I have the wrong IOS? Will it work with 12.2? I
have 12.3 now, currently. The wic-2t compatability listing does not
explicitly list 12.3, thats why Im asking.
|
| Just want to make sure that it isnt something other than just the card
being a dud.
| Show interface displays the fastethernet0/0 and 0/1 interfaces but not
the serials.
| Thanks in advance.
|

Suspect it is a software issue.  From cisco.com I find it is supported in:

Cisco IOS versions 12.0(7)XK, 12.1(1)T, 12.2, 12.2T

when it is installed in the NM-2FE2W network module.    Where it is
supported without restriction, it says it is supported in all versions.

I'd try loading a 12.2T image and see if it shows up.


=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)

iD8DBQE/vT5kE1XcgMgrtyYRAl/gAJsHnQ8XWz08R9SprdJJNap4iEI0qACfTXr6
F7nJ+ImWFz0uP7ftwbGaNvU=
=NZvw
-----END PGP SIGNATURE-----