[nsp] Newbie Question: Wic-2t on 3640 running IOS 12.3
bep at whack.org
Fri Nov 21 11:51:16 EST 2003
-----BEGIN PGP SIGNED MESSAGE-----
Gert Doering wrote:
| On Thu, Nov 20, 2003 at 02:21:25PM -0800, Bruce Pinsky wrote:
|>Suspect it is a software issue. From cisco.com I find it is supported in:
|>Cisco IOS versions 12.0(7)XK, 12.1(1)T, 12.2, 12.2T
|>when it is installed in the NM-2FE2W network module. Where it is
|>supported without restriction, it says it is supported in all versions.
|>I'd try loading a 12.2T image and see if it shows up.
| I would be very surpised if hardware that's supported in 12.2 main would
| get dropped from 12.3 without prior and well-visible announcement.
You're presuming that it was introduced in 12.2 mainline prior to 12.3
development being started and that 12.3 is a child of 12.2. Without
checking I can't say for sure, but it could have been introduced in 12.2T,
backported to 12.2 mainline and depending on the timing of the pull of the
12.3 dev branch from 12.2T, not appear in 12.3 mainline.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)
-----END PGP SIGNATURE-----
More information about the cisco-nsp