[c-nsp] Shutting down main interface

[Dave Temkin]

No, that will shut down the main (physical) interfaces and all of your
subinterfaces will go down.

-Dave

On Mon, 27 Dec 2004, Mario Antonio wrote:

> In the following configuration (Router 2621XM), can I shut down int f0/1
> since I am using only the sub-interfaces?
> What are the implications?
>
>
> ----------------------------------------------------------------------------
> -----------------
> !
> interface FastEthernet0/1
>  no ip address
>  speed 100
>  full-duplex
>  no cdp enable
> !
> interface FastEthernet0/1.1
>  encapsulation dot1Q 300
>  ip address 10.20.100.1 255.255.255.0
>  no cdp enable
> !
> interface FastEthernet0/1.2
>  encapsulation dot1Q 201
>  ip address 10.20.200.1 255.255.255.252
>  no cdp enable
> !
>
>
> Regards
>
> Mario Antonio
>
> ---
> [This e-mail was scanned for viruses by Webjogger's AntiVirus Protection System]
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>