[nsp] AToM (on 7600 w/ SUP720) : summary

[Tim Stevenson]

That is correct - if you install a DFC3A card in a PFC3B-XL system, the line card remains powered down.

Not sure what you mean, "then how about 'high avaibility solution'". What exactly is the question?

Tim

At 01:06 AM 1/8/2004, cisco-nsp-request at puck.nether.net maintained:
>one more snip
>
> * With a PFC3BXL and no DFC3A-equipped switching modules installed at bootup,
>   any DFC3A-equipped switching module installed after bootup remain powered down.
> * To use DFC3A-equipped switching modules with a PFC3BXL, the DFC3A-equipped switching
>   modules must be installed at bootup.
>
>And now question. If I correctly understand this too lines
>I can't insert DFC3A-equipped switching modules to chassis
>any time and start use. Is it true? and if yes then how about
>'high avaibility solution'?


Tim Stevenson, tstevens at cisco.com
Routing & Switching CCIE #5561
Technical Marketing Engineer, Catalyst 6500
Cisco Systems, http://www.cisco.com
IP Phone: 408-526-6759
********************************************************
The contents of this message may be *Cisco Confidential*
and are intended for the specified recipients only.