[nsp] NM-1FE2W problem in CISCO 3745

[Jack.W.Parks at alltel.com]

Do you have enough memory?  Or, You could try 12.2(8)T

From:
http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet
09186a00801aa71c.html

Product    |Cisco IOS |IOS Feature Sets Required |Minimum DRAM |Maximum
Supported  
Cisco 3745 | 12.2(8)T | Any IOS Feature Sets     |128 MB       |4
 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Fast Track
Technologies
Sent: Friday, January 23, 2004 4:42 AM
To: Majid Siddiq; cisco-nsp at puck.nether.net
Subject: Re: [nsp] NM-1FE2W problem in CISCO 3745


The IOS is 12.3(5).


----- Original Message -----
From: "Majid Siddiq" <majid at pie.net.pk>
To: "'Fast Track Technologies'" <fast_track at vsnl.com>;
<cisco-nsp at puck.nether.net>
Sent: Friday, January 23, 2004 3:52 PM
Subject: RE: [nsp] NM-1FE2W problem in CISCO 3745


> Make sure that the IOS of 3745 supports NM-1FE2W....majid
>
> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net 
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Fast Track 
> Technologies
> Sent: Friday, January 23, 2004 3:01 PM
> To: cisco-nsp at puck.nether.net
> Subject: [nsp] NM-1FE2W problem in CISCO 3745
>
> Hello,
>
> When we instal a brand new NM-1FE2W in the CISCO 3745 Router, the 
> module LED blinks once, and we get a message "Initialisation failed". 
> However, when we instal the same in a CISCO 3640 Router, the Module is

> detected and enabled without any problem.
>
> What could the problem be?
>
> Thanks and Regards
> Sunil Gulati
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
******************************************************************************************
The information contained in this message, including attachments, may contain 
privileged or confidential information that is intended to be delivered only to the 
person identified above. If you are not the intended recipient, or the person 
responsible for delivering this message to the intended recipient, ALLTEL requests 
that you immediately notify the sender and asks that you do not read the message or its 
attachments, and that you delete them without copying or sending them to anyone else.