[c-nsp] need help - issue with terminal/console

Bruce Pinsky bep at whack.org
Mon Jul 26 15:05:55 EDT 2004


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Chris Hale wrote:

| All -
|
|
| We attempted to upload a config from one router to another via the flash
| card.  This worked successfully with the IOS, but once we did it with the
| running-config, we apparently screwed up the console.  Now all we get is
| jibberish ascii characters on the console or terminal.
|
|
|
| Any ideas as to what caused this and how to remedy it?
|

Sounds like you changed your terminal settings somehow?  Perhaps an
invalide config-register command like forgetting 0x in front of the 2102?

If that's the case, you should be able to figure out the settings and
change your terminal.

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)

iD8DBQFBBVYTE1XcgMgrtyYRAttwAJ4n4XfRzm1t3o5p+CB07RJQYIwZ7gCdEiBD
O2OQn6Y+2zbjlkSGQb1mOsU=
=dS3Q
-----END PGP SIGNATURE-----


More information about the cisco-nsp mailing list