[c-nsp] need help - issue with terminal/console

[Chris Hale]

We've checked all the terminal speed settings, but no luck.  I'll check the
config-register.  

Thanks,
Chris

----------------------------------------------
Chris Hale
Peak Networks, Inc.
http://www.peaknetworks.com
800-PEAK-987
chris at peaknetworks.com
Motorola ACSP, Alvarion AIR, Certified Orthogon, Redline, Cisco, Terabeam
Partners.

 
 


-----Original Message-----
From: Bruce Pinsky [mailto:bep at whack.org] 
Sent: Monday, July 26, 2004 3:06 PM
To: Chris Hale
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] need help - issue with terminal/console

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Chris Hale wrote:

| All -
|
|
| We attempted to upload a config from one router to another via the flash
| card.  This worked successfully with the IOS, but once we did it with the
| running-config, we apparently screwed up the console.  Now all we get is
| jibberish ascii characters on the console or terminal.
|
|
|
| Any ideas as to what caused this and how to remedy it?
|

Sounds like you changed your terminal settings somehow?  Perhaps an
invalide config-register command like forgetting 0x in front of the 2102?

If that's the case, you should be able to figure out the settings and
change your terminal.

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)

iD8DBQFBBVYTE1XcgMgrtyYRAttwAJ4n4XfRzm1t3o5p+CB07RJQYIwZ7gCdEiBD
O2OQn6Y+2zbjlkSGQb1mOsU=
=dS3Q
-----END PGP SIGNATURE-----