[nsp] 6509 Help - Please! :)
John Wong
JohnWong at crimsonlogic.com
Thu Mar 18 22:14:41 EST 2004
Paul,
This looks seriously wrong... You should be getting a list
of VLANs something like on 1 of our switches (below). What I suspect
"could" be the problem is the use of VLAN other than 1 as
the native vlan for the MSFCs. Like you, I too configured
my sc0 into VLAN2 however, the native vlan for the MSFCs
still remain in 1 (as shown below). Maybe you'll want to
try changing the native vlan back to 1? There may be some
control protocols running over VLAN1 between the MLS SP
and RP maybe for MLS or otherwise.
XXX> (enable) sh trunk
* - indicates vtp domain mismatch
Port Mode Encapsulation Status Native vlan
-------- ----------- ------------- ------------ -----------
15/1 nonegotiate isl trunking 1
16/1 nonegotiate isl trunking 1
Port Vlans allowed on trunk
--------
---------------------------------------------------------------------
15/1 1-1005,1025-4094
16/1 1-1005,1025-4094
Port Vlans allowed and active in management domain
--------
---------------------------------------------------------------------
15/1 21-25,29,50,124,200-204,216,228
16/1 21-25,29,50,124,200-204,216,228
Port Vlans in spanning tree forwarding state and not pruned
--------
---------------------------------------------------------------------
15/1 21-25,29,50,124,200-204,216,228
16/1 21-25,29,50,124,200-204,216,228
> -----Original Message-----
> From: Paul Stewart [mailto:pauls at nexicom.net]
> Sent: Friday, March 19, 2004 10:47 AM
> To: 'Tim Stevenson'; cisco-nsp at puck.nether.net;
> cisco-nsp at puck.nether.net
> Subject: RE: [nsp] 6509 Help - Please! :)
>
>
> nrtc-6509> (enable) sh trunk
> * - indicates vtp domain mismatch
> # - indicates dot1q-all-tagged enabled on the port
> $ - indicates non-default dot1q-ethertype value
> Port Mode Encapsulation Status Native vlan
> -------- ----------- ------------- ------------ -----------
> 15/1 nonegotiate isl trunking 2
>
> Port Vlans allowed on trunk
> --------
> ---------------------------------------------------------------------
> 15/1
>
> Port Vlans allowed and active in management domain
> --------
> ---------------------------------------------------------------------
> 15/1
>
> Port Vlans in spanning tree forwarding state and not pruned
> --------
> ---------------------------------------------------------------------
>
> -----Original Message-----
> From: Tim Stevenson [mailto:tstevens at cisco.com]
> Sent: Thursday, March 18, 2004 9:45 PM
> To: Paul Stewart; cisco-nsp at puck.nether.net; cisco-nsp at puck.nether.net
> Subject: RE: [nsp] 6509 Help - Please! :)
>
>
> Vlan 2 should be added to 15/1 automatically. Try a sh trunk.
>
> Tim
>
> At 06:41 PM 3/18/2004, Paul Stewart quipped:
> >Hi Tim.. Thanks again..;)
> >
> >nrtc-6509> (enable) sh vlan
> >VLAN Name Status IfIndex
> Mod/Ports, Vlans
> >---- -------------------------------- --------- -------
> >------------------------
> >1 default active 6 4/1-48
> >2 Management_VLAN active 116 1/1-2
> > 3/1-48
> >
> >nrtc-6509> (enable) sh port 15/1
> >* = Configured MAC Address
> >
> >Port Name Status Vlan Duplex
> Speed Type
> >----- -------------------- ---------- ---------- ------ -----------
> >------------
> >15/1 connected trunk full
> 1000 Route
> >Switch
> >
> >Port Trap IfIndex
> >----- -------- -------
> >15/1 disabled 107
> >
> >Port Status ErrDisable Reason Port
> ErrDisableTimeout Action on
> >Timeout
> >---- ---------- ------------------- ----------------------
> >-----------------
> >15/1 connected - Enable
> No Change
> >
> >Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize
> >----- ---------- ---------- ---------- ---------- ---------
> >15/1 0 0 0 0 0
> >
> >Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts
> Giants
> >----- ---------- ---------- ---------- ---------- --------- ---------
> >---------
> >15/1 0 0 0 0 0 0
> >-
> >
> >On the msfc it is configured as (whole config post at bottom of my
> >original
> >message):
> >
> >interface Vlan2
> > ip address xxx.xxx.100.1 255.255.255.0
> >
> >nrtc-6509#show interfaces vlan 2
> >Vlan2 is down, line protocol is down
> >
> >I don't see reference to vlan 2 being on 15/1 which I realize now is
> >probably an issue..:)
> >
> >So I do this:
> >
> >nrtc-6509> (enable) set vlan 2 15/1
> >VLAN Mod/Ports
> >---- -----------------------
> >2 1/1-2
> > 3/1-48
> >
> >No luck as you can see.. What am I doing wrong?
> >
> >Thanks,
> >Paul
> >
> >-----Original Message-----
> >From: Tim Stevenson [mailto:tstevens at cisco.com]
> >Sent: Thursday, March 18, 2004 9:37 PM
> >To: Paul Stewart; cisco-nsp at puck.nether.net;
> cisco-nsp at puck.nether.net
> >Subject: RE: [nsp] 6509 Help - Please! :)
> >
> >
> >I already checked the config, it looks ok to me, assuming
> you moved sc0
> >to vlan 2.
> >
> >Make sure vlan 2 exists, is active in sh vlan, that sc0 is
> in vlan 2 &
> >sc0 is active, and that you have a vlan2 int on the msfc and
> that it is
> >no shut.
> >
> >That should do it - if not, not sure what the issue might
> be. Is vlan 2
> >showing active & forwarding on 15/1?
> >
> >What is the config of the msfc, didn't see it in the original post.
> >
> >Tim
> >
> >At 06:25 PM 3/18/2004, Paul Stewart quipped:
> >>And that is not happening... Did you see anything wrong with the
> >>config? I realize it's asking yourself and others for
> quite a bit of
> >>"reading" but we're kinda stuck at this point and don't
> know where to
> >>turn for assistance other than this list...:)
> >>
> >>Thanks again,
> >>
> >>Paul
> >>
> >>
> >>-----Original Message-----
> >>From: cisco-nsp-bounces at puck.nether.net
> >>[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Tim
> Stevenson
> >>Sent: Thursday, March 18, 2004 9:17 PM
> >>To: cisco-nsp at puck.nether.net; cisco-nsp at puck.nether.net
> >>Subject: Re: [nsp] 6509 Help - Please! :)
> >>
> >>
> >>If sc0 is active in a given VLAN, autostate should bring the vlan
> >>interface up, even w/no other ports are connected in that vlan.
> >>
> >>Tim
> >>
> >>At 05:43 PM 3/18/2004, cisco-nsp-request at puck.nether.net quipped:
> >>>Date: Thu, 18 Mar 2004 20:37:41 -0500
> >>>From: "Paul Stewart" <pauls at nexicom.net>
> >>>Subject: RE: [nsp] 6509 Help - Please! :)
> >>>To: "'John Wong'" <JohnWong at crimsonlogic.com>,
> >>> <cisco-nsp at puck.nether.net>
> >>>Message-ID: <001001c40d52$c5280470$640aa8c0 at pstewart>
> >>>Content-Type: text/plain; charset="us-ascii"
> >>>
> >>>Actually not yet... Didn't realize that.. Thought that the
> interface
> >>>would be up/down instead...
> >>>
> >>>We're going to bring this up live in the middle of the night (last
> >>>try for this week) and see what happens... Be presuming
> something in
> >>>my config is wrong but if nobody sees anything wrong then
> maybe it's
> >>>that simple.... I'll have to laugh if that's it... Been suffering
> >>>brainfreeze now from look at this too long..;)
> >>>
> >>>Paul
> >>
> >>
> >>Tim Stevenson, tstevens at cisco.com
> >>Routing & Switching CCIE #5561
> >>Technical Marketing Engineer, Catalyst 6500
> >>Cisco Systems, http://www.cisco.com
> >>IP Phone: 408-526-6759
> >>********************************************************
> >>The contents of this message may be *Cisco Confidential*
> >>and are intended for the specified recipients only.
> >>
> >>_______________________________________________
> >>cisco-nsp mailing list cisco-nsp at puck.nether.net
> >>https://puck.nether.net/mailman/listinfo/cisco-nsp
> >>archive at http://puck.nether.net/pipermail/cisco-nsp/
> >
> >
> >Tim Stevenson, tstevens at cisco.com
> >Routing & Switching CCIE #5561
> >Technical Marketing Engineer, Catalyst 6500
> >Cisco Systems, http://www.cisco.com
> >IP Phone: 408-526-6759
> >********************************************************
> >The contents of this message may be *Cisco Confidential*
> >and are intended for the specified recipients only.
>
>
> Tim Stevenson, tstevens at cisco.com
> Routing & Switching CCIE #5561
> Technical Marketing Engineer, Catalyst 6500
> Cisco Systems, http://www.cisco.com
> IP Phone: 408-526-6759
> ********************************************************
> The contents of this message may be *Cisco Confidential*
> and are intended for the specified recipients only.
>
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
More information about the cisco-nsp
mailing list