[c-nsp] Multiple Static Routes on Cisco

[Bruce Pinsky]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Saad wrote:
| Hi,
|
|
| I have a Cisco 3640 router with internet connectivity using WIC-1ADSL
| card. There is no LAN connected to the router and no traffic orignating
| from the router because we have a voice termination setup. Voice traffic
| comes in from 3 IP's. I have a default route to the ATM0 interface on
| router. What I want is to add another WIC-1ADSL card on the router to
| increase the bandwidth. Default route can not be used in that scenario
| because we'll have 2 IP's assigned to the router. I want complete step
| by step configuration of static routes on the Cisco so that the traffic
| coming in from one IP goes through ATM0 interface and the traffic from
| other 2 IP's passes through the ATM1 interface.
|
|

What you want to do isn't done with static routes.  Since you want to route
based on source ip address instead of destination, you want policy routing.
~ See:

http://www.cisco.com/warp/public/732/Tech/plicy_wp.htm
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800c75d2.html

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)

iD8DBQFBnwneE1XcgMgrtyYRAhOFAKCu05yJBr55j45aMnpO/oA3ZuXZ9wCg7nu/
BrSj5IEHC1eSeB9Ohw8Aajs=
=97NU
-----END PGP SIGNATURE-----