[c-nsp] weird weird weird 3620
Mustafa N. Deeb
mustafa at palnet.com
Wed Nov 24 05:53:44 EST 2004
well here it is
i've just noticed the PCI errors,
is that a problem in the Card , or the Router's Bus ?
System Bootstrap, Version 11.1(19)AA, EARLY DEPLOYMENT RELEASE SOFTWARE
(fc1)
Copyright (c) 1998 by cisco Systems, Inc.
C3600 processor with 57344 Kbytes of main memory
Main memory is configured to 32 bit mode with parity disabled
program load complete, entry point: 0x80008000, size: 0x74c270
Self decompressing the image :
####################################################################################
[OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
00002B 0X00658200 Two port Channelized E1 (120 Ohm - TP)
0000D8 0X00178610 Dual FE Combo Port Module, 2 WAN
0X00098670 public buffer pools
0X00211000 public particle pools
TOTAL: 0X00A79E80
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 11Mb.
Using 19 percent iomem. [11Mb/56Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-I-M), Version 12.3(9b), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 18-Aug-04 22:14 by dchih
Image text-base: 0x60008B00, data-base: 0x60CBC000
%ERR-1-GT64010: Fatal error, PCI Master abort
cause=0x0100E483, mask=0x0CD01F00, real_cause=0x00000400
bus_err_high=0x00000000, bus_err_low=0x03880000, addr_decode_err=0x14000470
cisco 3620 (R4700) processor (revision 0x81) with 46080K/11264K bytes of
memory.
Processor board ID 08359752
R4700 CPU at 80MHz, Implementation 33, Rev 1.0
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
2 Ethernet/IEEE 802.3 interface(s)
2 Channelized E1/PRI port(s)
DRAM configuration is 32 bits wide with parity disabled.
29K bytes of non-volatile configuration memory.
4096K bytes of processor board System flash (Read/Write)
20480K bytes of processor board PCMCIA Slot1 flash (Read/Write)
Press RETURN to get started!
*Mar 1 00:00:12.623: %FECPM-3-DSCC4: DSCC4 chip init slot 1 failed
-Traceback= 60242394 6023C424 6052B020 6052B11C 604A9B28 603BFB40 603BFD50
60480CA4 60480C88
*Mar 1 00:00:12.627: %FECPM-1-INITFAIL: NM slot 1: PCI dev 13 init failed
*Mar 1 00:00:12.699: %FECPM-1-DISCOVER: NM slot 1: only 2 PCI dev found
*Mar 1 00:00:14.655: %LINK-3-UPDOWN: Interface Ethernet1/0, changed state
to up
00:00:14: %LINK-3-UPDOWN: Interface Ethernet1/1, changed state to up
00:00:15: %SYS-5-CONFIG_I: Configured from memory by console
00:00:15: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet1/0,
changed state to down
00:00:16: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet1/1,
changed state to down
00:00:16: %CONTROLLER-5-UPDOWN: Controller E1 0/0, changed state to up
00:00:16: %CONTROLLER-5-UPDOWN: Controller E1 0/1, changed state to up
00:00:17: %LINK-3-UPDOWN: Interface Serial0/0:0, changed state to up
00:00:17: %LINK-3-UPDOWN: Interface Serial0/1:0, changed state to up
00:00:17: %LINK-5-CHANGED: Interface Ethernet1/0, changed state to
administratively down
00:00:17: %LINK-5-CHANGED: Interface Ethernet1/1, changed state to
administratively down
00:00:17: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-I-M), Version 12.3(9b), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 18-Aug-04 22:14 by dchih
00:00:17: %SNMP-5-COLDSTART: SNMP agent on host XXX is undergoing a cold
start
00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0:0,
changed state to up
00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1:0,
changed state to up
----- Original Message -----
From: "Josh Duffek" <consultantjd16 at ridemetro.org>
To: "Mustafa N. Deeb" <Mustafa at palnet.com>; <cisco-nsp at puck.nether.net>
Sent: Tuesday, November 23, 2004 10:41 PM
Subject: RE: [c-nsp] weird weird weird 3620
> Prove it...
>
> Sh ver
> Sh diag
> Sh run
> ...etc
>
> josh duffek network engineer
> consultantjd16 at ridemetro.org
>
>> -----Original Message-----
>> From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-
>> bounces at puck.nether.net] On Behalf Of Mustafa N. Deeb
>> Sent: Tuesday, November 23, 2004 2:34 PM
>> To: cisco-nsp at puck.nether.net
>> Subject: [c-nsp] weird weird weird 3620
>>
>> hi
>>
>> i have a 3620 with NM-2FE2W and NM-2CE1B
>>
>> tried 12.3 and 12.2
>>
>>
>> FastEthernets Appear as regular 10MG Ethernet interface
>>
>> although "show diag " shows it is a Fast Ethernet interface..
>>
>> is that a hardware issue ?
>> Cheers
>>
>>
>> Mustafa N. Deeb
>> Technical Director
>> Palnet Communications Ltd.
>> Mustafa at palnet.com
>> _______________________________________________
>> cisco-nsp mailing list cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
More information about the cisco-nsp
mailing list