[c-nsp] %SYS-4-CONFIG_NEWER: Configuration from version 12.3 may not be correctly understood

[Brant I. Stevens]

Your bootloader is the culprit...

> BOOTLDR: 7200 Software (C7200-KBOOT-M), Version 12.1(8a)E, EARLY
> DEPLOYMENT RELEASE SOFTWARE (fc1)
> 

If you upgrade the bootloader to the 12.3x family, you should be good...
Though I have to say that I've never seen this cause a problem.

You may not even need the bootloader...
On 09/02/2004 11:02 AM, "elliot moore" <nsp at devnull.org.uk> wrote:

> Hello list, sorry I tried to search for this, but got an 404 error from
> http://puck.nether.net/cgi-bin/htsearch
> 
> My question:
> I have taken ownership of a 7204VXR NPE400
> 
> But at boot I get the message:
> %SYS-4-CONFIG_NEWER: Configuration from version 12.3 may not be
> correctly understood
> %SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
> 
> The config is empty/reset/defaults
> My IOS IS 12.3 - is this conflicting with the Bootstrap?
> Should this be happening, this does not look correct, is it safe to
> proceed?
> 
> e.
> 
> 
> 
> Router#sh ver
> Cisco Internetwork Operating System Software
> IOS (tm) 7200 Software (C7200-IS-M), Version 12.3(5a), RELEASE SOFTWARE
> (fc1)
> Copyright (c) 1986-2003 by cisco Systems, Inc.
> Compiled Mon 24-Nov-03 21:24 by kellythw
> Image text-base: 0x60008AF4, data-base: 0x61C1A000
> 
> ROM: System Bootstrap, Version 12.2(4r)B2, RELEASE SOFTWARE (fc2)
> BOOTLDR: 7200 Software (C7200-KBOOT-M), Version 12.1(8a)E, EARLY
> DEPLOYMENT RELEASE SOFTWARE (fc1)
> 
> Router uptime is 3 minutes
> System returned to ROM by reload at 15:48:47 UTC Thu Sep 2 2004
> System image file is "disk0:c7200-is-mz.123-5a.bin"
> Last reload reason: Reload command
> 
> 
> cisco 7204VXR (NPE400) processor (revision A) with 114688K/16384K bytes
> of memory.
> Processor board ID 23685273
> R7000 CPU at 350MHz, Implementation 39, Rev 3.3, 256KB L2, 4096KB L3
> Cache
> 4 slot VXR midplane, Version 2.3
> 
> Last reset from power-on
> Bridging software.
> X.25 software, Version 3.0.0.
> 
> PCI bus mb0_mb1 has 400 bandwidth points
> PCI bus mb2 has 400 bandwidth points
> 
> 4 FastEthernet/IEEE 802.3 interface(s)
> 125K bytes of non-volatile configuration memory.
> 
> 47040K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
> 8192K bytes of Flash internal SIMM (Sector size 256K).
> Configuration register is 0x2102
> 
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/