[c-nsp] cef inconsistency auto-repair ?

[Jared Mauch]

On Tue, Sep 07, 2004 at 12:46:01PM +0200, Pierfrancesco Caci wrote:
> 
> Does someone know how to enable the 2 things marked with the arrow?
> 
> G12416A-ST_TOR02#sh ip cef inc
> Consistency checker master control: enabled
> Table consistency checker state:
>  lc-detect: enabled
>   0/0/0/0 queries sent/ignored/checked/iterated
>  scan-lc: enabled [83 prefixes checked every 60s]
>   0/0/81350521/174 queries sent/ignored/checked/iterated
>  scan-rp: enabled [83 prefixes checked every 60s]
>   81322800/0/0/0 queries sent/ignored/checked/iterated
>  scan-rib: enabled [1000 prefixes checked every 60s]
>   195466289/0/195466289/0 queries sent/ignored/checked/iterated
>  full-scan-rib: enabled
>   0/0/0/0 queries sent/ignored/checked/iterated
>  full-scan-rp: enabled
>   0/0/0/0 queries sent/ignored/checked/iterated
>  full-scan-lc: enabled
>   0/0/0/0 queries sent/ignored/checked/iterated
> Inconsistency error messages are disabled                <<=========
> Inconsistency auto-repair is disabled                    <<=========
> Inconsistency auto-repair runs: 0
> Inconsistency statistics: 0 confirmed, 0/16 recorded
> Table test modes: 
>  Insert mode: normal
>  Remove mode: normal

	Been around for awhile.. can drive up the cpu though 
sometimes.. 

Router(config)#ip cef  table consistency-check ?
  auto-repair    Control auto-repair function
  data-checking  Perform data consistency check
  error-message  Generate error message on inconsistency detection
  type           Type of consistency check to configure

-- 
Jared Mauch  | pgp key available via finger from jared at puck.nether.net
clue++;      | http://puck.nether.net/~jared/  My statements are only mine.