[c-nsp] faulty NPE-G1

[Ian Dickinson]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

If you have any PA's installed, pull them and then boot again.
I've had this symptom on NPE-400 with a bad PA.  If this doesn't
help or isn't relevant, you're probably heading for an RMA.

Ian

- -----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net]On Behalf Of richard bosire
Sent: 22 September 2004 06:59
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] faulty NPE-G1


Howdy'

I have  a brand new Cisco 7206VXR  with NPE-G1. I suspect to NPE-G1
to have 
gone kaputt. It has been working ok in the test lab but now it doesnt
boot. 

when powered on,  the LEDs for power and Gi0/1-3 come on that is it ,
doesnt 
go through the usual boot up sequence .
Also there is nothing  being output on the console nor the Aux port,

Could it be dead or there is something else  I need to check?

regards

./bosire
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

-----BEGIN PGP SIGNATURE-----
Version: PGP 7.0.4

iQA/AwUBQVFnp8Oztyrd+IYqEQKljwCgslD+zh5PLiaDlelHS4yAmSeV8F4AoOr7
pi6XSMvVagwy99f672v3DUyU
=OH+T
-----END PGP SIGNATURE-----