[c-nsp] 2651XM

[Clayton Kossmeyer]

Hi Jichen -

You might have a look here to try and reset the console baud rate:

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008009433b.shtml#band_reset

Regards,

Clay

On Mon, Apr 18, 2005 at 09:01:28AM +0600, Jichen Thinley wrote:
> Hi
> 
> We have a pecular problem of 2651XM model router, when it boots it does 
> not boot to the image it has it gives a strange charaters on the 
> temrinal screen. We set the console speed on 2600 bits, 9600,19200 bits 
> and hardware flow control on and off. We even changed the flash, we had 
> even tried the break sequence and it does not coem to ROMMON mode.
> 
> Any suggestions and ideas how to recover. The router has all its led on 
> after the boot , power . LED etc..
> 
> it gives this output when booting
> 
> ???..g???..???7.???R???r.S.???..g???..???7.???R???r.S.|
> 
> 
> 
> Regards
> 
> Jichen
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/