[c-nsp] Trouble with a NM-2CT1-CSU module

Bruce Pinsky bep at whack.org
Wed Aug 3 19:06:12 EDT 2005


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

james edwards wrote:
| Other side:
|
| Serial0/1 is up, line protocol is down
|   Hardware is PQUICC with Fractional T1 CSU/DSU
|   Description: T-1 to SF main CO
|   Internet address is 10.444.0.26/30
|   MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
|      reliability 128/255, txload 1/255, rxload 1/255
|   Encapsulation FRAME-RELAY IETF, loopback not set
|   Keepalive set (10 sec)
|   LMI enq sent  518, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down
|   LMI enq recvd 0, LMI stat sent  0, LMI upd sent  0
|   LMI DLCI 1023  LMI type is CISCO  frame relay DTE
|   Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0
|   Last input 06:15:05, output 00:00:07, output hang never
|   Last clearing of "show interface" counters 01:26:59
|   Queueing strategy: fifo
|   Output queue 0/40, 0 drops; input queue 0/75, 0 drops
|   5 minute input rate 0 bits/sec, 0 packets/sec
|   5 minute output rate 0 bits/sec, 0 packets/sec
|      0 packets input, 0 bytes, 0 no buffer
|      Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
|      977 input errors, 1 CRC, 581 frame, 0 overrun, 0 ignored, 395 abort
|      785 packets output, 10294 bytes, 0 underruns
|      0 output errors, 0 collisions, 171 interface resets
|      0 output buffer failures, 0 output buffers swapped out
|      2 carrier transitions
|      DCD=up  DSR=up  DTR=up  RTS=up  CTS=up
|
| !
| !

Also seems to indicate a clocking problem.  Likely getting garbage from the
other side.


How about the "show service-module" command instead on this side?

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.0 (MingW32)

iD8DBQFC8U3kE1XcgMgrtyYRArZbAJ42RAjkE9k5gs+gE8rg1o5ckCvDUACg0lB6
jZh1c/F1y35VkmiCHQ/gENY=
=4fVw
-----END PGP SIGNATURE-----


More information about the cisco-nsp mailing list