[c-nsp] Trouble with a NM-2CT1-CSU module

[james edwards]

> Also seems to indicate a clocking problem.  Likely getting garbage from
the
> other side.
>
>
> How about the "show service-module" command instead on this side?


rio_rancho_management_router#show service-module Serial0/1
Module type is T1/fractional
    Hardware revision is 0.96, Software revision is 0.2,
    Image checksum is 0xED22BEC5, Protocol revision is 0.1
Receiver has no alarms.
Framing is ESF, Line Code is B8ZS, Current clock source is line,
Fraction has 24 timeslots (64 Kbits/sec each), Net bandwidth is 1536
Kbits/sec.
Last module self-test (done at startup): Passed
Last clearing of alarm counters 1d03h
    loss of signal        :    1, last occurred 1d03h
    loss of frame         :   10, last occurred 02:32:17
    AIS alarm             :    7, last occurred 02:32:17
    Remote alarm          :    7, last occurred 01:30:08
    Module access errors  :    0,
Total Data (last 96 15 minute intervals):
    0 Line Code Violations, 1020 Path Code Violations
    0 Slip Secs, 64561 Fr Loss Secs, 0 Line Err Secs, 5 Degraded Mins
    2 Errored Secs, 2 Bursty Err Secs, 15 Severely Err Secs, 64549 Unavail
Secs
Data in current interval (43 seconds elapsed):
    0 Line Code Violations, 0 Path Code Violations
    0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
    0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
rio_rancho_management_router#