[c-nsp] MPLS EXP on Engine0 LCs

[kon]

It will not work for ATM E0 in frfab direction at least

class-map match-any test
  match mpls exp  5

policy-map test
  class test
    bandwidth percent 90

(config-if)#service-policy output test
% service-policy configuration is not allowed on this interface.

(config-if-atm-vc)#service-policy output test
% service-policy configuration is not allowed on the sub interface.


don't think it will work for POS either

also look for "mpls" in

http://www.cisco.com/en/US/customer/products/hw/routers/ps167/products_tech_
note09186a0080094c00.shtml

Kostas


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net]On Behalf Of
BRA-SAO-Tomaiz,Anderson Goncalves
Sent: Wednesday, August 03, 2005 10:52 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] MPLS EXP on Engine0 LCs




Hi people!!

Anybody in the list has configured QoS using Engine0 LineCards at GSR
routers?

We're starting to configured MDRR in some POS Engine0 cards but we are
not sure if it will work cause  I have found several documents but none
of them specifies that the MPLS EXP bits are going to be matched against
the precedence command in the cos-queue-group.

Is there anybody that has already configured E0 LCs matching MPLS EXP?

Thanks!

Anderson Tomaiz



_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.