[c-nsp] PA-2H and hardware revision

[Martin Robinson]

Hello Richard,

You need revision 1.3 or higher to work in a vxr chassis.  The lower
revisions only work in the non-vxr chassis.  I don't belive these can be
upgraded.

Martin.

___________________________________________________

Martin Robinson
Network Hardware Resale, LLC 
Merchants Court 
Singaporestraat 66
1175 RA Lijnden
The Netherlands
www.networkhardware.com

Direct: +31 (0) 20 449 6927
Fax: +31 (0) 20 449 6923
martin at networkhardware.com 
AIM: martinNHR  

Network Hardware Resale 
"The World's Largest Resource for Pre-Owned and
Used CISCO Network Hardware"
__________________________________________________


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of richard bosire
Sent: Wednesday, August 24, 2005 12:00 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] PA-2H and hardware revision

howdy'

I have a PA-2H which is not being accepted the routercisco 7206VXR
(NPE400) 
processor (revision A)


%PA-3-REVNOTSUPPORTED: PA in slot3 (Mx HSSI) requires base h/w revision
of
(1.3s       
% Please answer 'yes' or 'no'.                              
Would you l
%PA-3-DEACTIVATED: port adapter in bay [3] powered off.

%PA-2-PABRIDGE: Failed to config bridge for PA 3                        
Would you like to enter
%SYS-6-BOOT_MESSAGES: Messages above this line are from th

the router has  c7200-is-mz.121-3a.E5 version of the ios

Does this mean this cant be used used on this particular router or there
is a 
way the hardware revision can be changed 1.3s?
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/