[c-nsp] PA-2H and hardware revision

[Joe McGuckin]

Robert,

Would you like my NP-2R token ring card for your lab?

You never know when it will come in handy - like when you need something to
throw at a cockroach.

Joe


On 8/24/05 1:50 PM, "Robert E.Seastrom" <rs at seastrom.com> wrote:

> 
> Notwithstanding the asking prices that some folks seem to believe they
> can get for a PA-2H Rev B, when offered with no reserve they seem to
> be go for somewhere between $10 and $70 on eBay.
> 
> Cisco used to have an upgrade program for these, but it's long since over.
> 
> Keep it around though; never know when it might come in handy in a
> non-vxr 7206 in the lab.
> 
>                                       ---Rob
> 
> 
> "Martin Robinson" <Martin at networkhardware.com> writes:
> 
>> Hello Richard,
>> 
>> You need revision 1.3 or higher to work in a vxr chassis.  The lower
>> revisions only work in the non-vxr chassis.  I don't belive these can be
>> upgraded.
>> 
>> Martin.
>> 
>> ___________________________________________________
>> 
>> Martin Robinson
>> Network Hardware Resale, LLC
>> Merchants Court 
>> Singaporestraat 66
>> 1175 RA Lijnden
>> The Netherlands
>> www.networkhardware.com
>> 
>> Direct: +31 (0) 20 449 6927
>> Fax: +31 (0) 20 449 6923
>> martin at networkhardware.com
>> AIM: martinNHR  
>> 
>> Network Hardware Resale
>> "The World's Largest Resource for Pre-Owned and
>> Used CISCO Network Hardware"
>> __________________________________________________
>> 
>> 
>> -----Original Message-----
>> From: cisco-nsp-bounces at puck.nether.net
>> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of richard bosire
>> Sent: Wednesday, August 24, 2005 12:00 PM
>> To: cisco-nsp at puck.nether.net
>> Subject: [c-nsp] PA-2H and hardware revision
>> 
>> howdy'
>> 
>> I have a PA-2H which is not being accepted the routercisco 7206VXR
>> (NPE400) 
>> processor (revision A)
>> 
>> 
>> %PA-3-REVNOTSUPPORTED: PA in slot3 (Mx HSSI) requires base h/w revision
>> of
>> (1.3s       
>> % Please answer 'yes' or 'no'.
>> Would you l
>> %PA-3-DEACTIVATED: port adapter in bay [3] powered off.
>> 
>> %PA-2-PABRIDGE: Failed to config bridge for PA 3
>> Would you like to enter
>> %SYS-6-BOOT_MESSAGES: Messages above this line are from th
>> 
>> the router has  c7200-is-mz.121-3a.E5 version of the ios
>> 
>> Does this mean this cant be used used on this particular router or there
>> is a 
>> way the hardware revision can be changed 1.3s?
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>> 
>> 
>> 
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 

-- 

Joe McGuckin

ViaNet Communications
994 San Antonio Road
Palo Alto, CA  94303

Phone: 650-213-1302
Cell:  650-207-0372
Fax:   650-969-2124