[c-nsp] 100 meg throughput

[Paul Stewart]

:)  Thanks.. Yeah we've done that to manually check on it once in a
while....  

-----Original Message-----
From: David J. Hughes [mailto:bambi at Hughes.com.au] 
Sent: Wednesday, December 14, 2005 9:29 PM
To: Paul Stewart
Cc: Eric Andrews; Chris Cappuccio; cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] 100 meg throughput


Just to state the obvious, but you could always set a 30 second
load-interval on the interface and have a closer look at the average
traffic load.


David
...


On 15/12/2005, at 12:27 PM, Paul Stewart wrote:

> Thanks for all the responses....
>
> When it gets over 80 meg it doesn't make it much further... Haven't 
> been sure yet whether the traffic just isn't there, or if it's 
> flatlining the connection... Either way, I'm making the assumption 
> that 80 is the max on a 100 meg connection **based** on 5 minute 
> averages... It seems like a safe bet in my opinion...
>
> Paul
>
>
> -----Original Message-----
> From: Chris Cappuccio [mailto:chris at nmedia.net]
> Sent: Wednesday, December 14, 2005 7:43 PM
> To: Eric Andrews
> Cc: Paul Stewart; cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] 100 meg throughput
>
> Eric Andrews [eric.m.andrews at gmail.com] wrote:
>>
>> it depends on the configuration of the interface, the packet size, 
>> and
>
>> what it's connected to. what happens after 80Mbps?
>>
>
> If your 5 minute average shows that your pipe is at 80% utilization, 
> then it's likely that you are actually spiking at 100% at which times 
> you are dropping packets and providing a lower quality service.
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>