[c-nsp] Trying to get an ATM ciruit up

[Dave Temkin]

Is it HEC or PLCP?  You may want to try changing between the two on the
main ATM interface (atm framing cbitplcp/etc)
-Dave

On Thu, 20 Jan 2005, Voll, Scott wrote:

> Router1#sh controllers atm
> ATM4/0/0: Port adaptor specific information
>  Hardware is DS3 (45000Kbps) port adaptor
>  Framer is PMC PM7345 S/UNI-PDH, SAR is LSI ATMIZER II
>  Firmware rev: G152, ATMIZER II rev: 3
>  Framing mode: DS3 C-bit ADM
>  Default Maximum Queue Length: 0
>  Facility alarm: OOF LossOfCellDelineation
> Facility statistics: current interval elapsed 524 seconds
>
> -----Original Message-----
>
> Can anyone give me a hit as to what I'm doing wrong?
>
> I'm trying to bring up an ATM DS3 and I'm getting Rx loss.
>
> My config is below.  Am I missing more configurations?
>
> interface ATM4/0/0
>  no ip address
> !
> !
> interface ATM4/0/0.33 point-to-point
>  description XXXXXX
>  ip address xxx.xxx.xxx.xxx 255.255.255.252
>  pvc 1/33
>   vbr-nrt 1024 1024
>   encapsulation aal5snap
>
> This is a FR to ATM configuration using a CAT 6509 flexwan / ATM DS3
> Card (enhanced).
>
> Telco is pointing finger my way.  Do I need to setup Controller in
> global config?
>
> TIA
>
> Scott
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>