[c-nsp] RPR+ on Cisco 7513

[Jon Lewis]

On Tue, 25 Jan 2005, Rodney Dunn wrote:

> I don't think this has anything to do with it
> but can you move the disk to disk1: for the
> RSP in slot 7 just so they are the same.

Actually, I wondered about that.

> > boot-start-marker
> > boot system flash disk1:rsp-k4pv-mz.120-27.S4.bin
> > boot-end-marker
> > hw-module slot 6 image disk1:rsp-k4pv-mz.120-27.S4.bin
> > hw-module slot 7 image disk0:rsp-k4pv-mz.120-27.S4.bin

> > Router# sho redundancy
> > Redundant System Information :
> > Current Processor Information :
> > -------------------------------
> >                Active Location = slot 6
> >                           BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1;
> > Peer Processor Information :
> > ----------------------------
> >               Standby Location = slot 7
> >                           BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1;

If slot 7 was told to boot disk0:rsp-k4pv-mz.120-27.S4.bin, why does it
say it's running disk1:rsp-k4pv-mz.120-27.S4.bin,1?

I like to keep the slot/disk's in dual RSP 7500s identical just so there's
no confusion.  If RSP1 has slot0 and disk1, RSP2 will have slot0 and
disk1 (not disk0 and slot1)...and more or less the same files on each
device.

----------------------------------------------------------------------
 Jon Lewis                   |  I route
 Senior Network Engineer     |  therefore you are
 Atlantic Net                |
_________ http://www.lewis.org/~jlewis/pgp for PGP public key_________