[c-nsp] RPR+ on Cisco 7513
Rodney Dunn
rodunn at cisco.com
Tue Jan 25 13:17:57 EST 2005
Since it's in the lab can you try a couple
things:
a) Take out the VIP2-50
b) How much memory is on the 4-50's?
c) What does: sh cef linecard say?
d) Turn CEF back on for Fas2/0/0. You have
turned it off:
> interface FastEthernet2/0/0
> ip address 10.0.6.53 255.255.255.0
> no ip directed-broadcast
> no ip route-cache cef
> no ip route-cache distributed
> no ip route-cache
I don't think this has anything to do with it
but can you move the disk to disk1: for the
RSP in slot 7 just so they are the same.
Then capture:
sh run
sh redund
sh cef linecard
Do the force switchover and capture the console
output from both RSP's.
After it's cut over get:
sh redund
sh redund history
If you can get me console access to the RSP's
I can look at it with you.
Rodney
On Tue, Jan 25, 2005 at 11:10:47AM -0500, Dan Benson wrote:
> Here is the config, show DIAG and VER. Thanks again for the insight.. //db
>
>
> Building configuration...
>
> Current configuration : 1363 bytes
> !
> version 12.0
> no service pad
> service timestamps debug uptime
> service timestamps log uptime
> no service password-encryption
> service single-slot-reload-enable
> !
> hostname Router
> !
> boot-start-marker
> boot system flash disk1:rsp-k4pv-mz.120-27.S4.bin
> boot-end-marker
> !
> redundancy
> no keepalive-enable
> mode sso
> logging snmp-authfail
>
> !
> ip subnet-zero
> ip cef distributed
> ip ssh time-out 120
> ip ssh authentication-retries 3
> hw-module slot 6 image disk1:rsp-k4pv-mz.120-27.S4.bin
> hw-module slot 7 image disk0:rsp-k4pv-mz.120-27.S4.bin
> !
> !
> !
> interface GigabitEthernet0/0/0
> no ip address
> no ip directed-broadcast
> load-interval 30
> negotiation auto
> !
> interface FastEthernet1/0/0
> no ip address
> no ip directed-broadcast
> shutdown
> !
> interface FastEthernet2/0/0
> ip address 10.0.6.53 255.255.255.0
> no ip directed-broadcast
> no ip route-cache cef
> no ip route-cache distributed
> no ip route-cache
> !
> interface Hssi3/0/0
> no ip address
> no ip directed-broadcast
> shutdown
> !
> interface Hssi3/0/1
> no ip address
> no ip directed-broadcast
> shutdown
> !
> interface ATM4/0/0
> no ip address
> no ip directed-broadcast
> shutdown
> no atm enable-ilmi-trap
> no atm ilmi-keepalive
> !
> ip default-gateway 10.0.6.1
> ip classless
> !
> !
> !
> !
> line con 0
> line aux 0
> line vty 0 4
> exec-timeout 0 0
> password gnaps123
> login
> length 0
> !
> no cns aaa enable
> end
>
>
> Router# sho redundancy
> Redundant System Information :
> ------------------------------
> Available system uptime = 28 minutes
> Switchovers system experienced = 0
> Standby failures = 0
> Last switchover reason = none
>
> Hardware Mode = Duplex
> Configured Redundancy Mode = sso
> Operating Redundancy Mode = sso
> Maintenance Mode = Disabled
> Communications = Up
>
> Current Processor Information :
> -------------------------------
> Active Location = slot 6
> Current Software state = ACTIVE
> Uptime in current state = 27 minutes
> Image Version = Cisco Internetwork Operating System
> Software
> IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
> (fc1)
> Technical Support: http://www.cisco.com/techsupport
> Copyright (c) 1986-2004 by cisco Systems, Inc.
> Compiled Tue 21-Dec-04 17:56 by pwade
> BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1;
> Configuration register = 0x2102
>
> Peer Processor Information :
> ----------------------------
> Standby Location = slot 7
> Current Software state = STANDBY HOT
> Uptime in current state = 0 minutes
> Image Version = Cisco Internetwork Operating System
> Software
> IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
> (fc1)
> Technical Support: http://www.cisco.com/techsupport
> Copyright (c) 1986-2004 by cisco Systems, Inc.
> Compiled Tue 21-Dec-04 17:56 by pwade
> BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1;
> CONFIG_FILE =
> BOOTLDR =
> Configuration register = 0x2102
> *
>
> *Router#sho diagbus 6
> Slot 6:
> EEPROM format version 1
> Route/Switch Processor 4, FRU: RSP4+=, HW rev 1.06, board
> revision A0
> Serial number: 21016486 Part number: 73-5512-02
> Test history: 0x14 RMA number: 00-00-00
> Flags: cisco 7000 board; 7500 compatible
>
> EEPROM contents (hex):
> 0x20: 01 1A 01 06 01 40 AF A6 49 15 88 02 14 00 00 00
> 0x30: 50 FF FF 02 00 00 00 00 00 00 00 00 00 00 00 00
> Router#sho diagbus 7
> Slot 7:
> EEPROM format version 1
> Route/Switch Processor 4, FRU: RSP4+=, HW rev 1.06, board
> revision A0
> Serial number: 28443840 Part number: 73-5512-02
> Test history: 0x00 RMA number: 00-00-00
> Flags: cisco 7000 board; 7500 compatible
>
> EEPROM contents (hex):
> 0x20: 01 1A 01 06 01 B2 04 C0 49 15 88 02 00 00 00 00
> 0x30: 50 00 00 02 00 00 00 00 00 00 00 00 00 00 00 00
> Router#
>
>
> Router#sho ver
> Cisco Internetwork Operating System Software
> IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
> (fc1)
> Technical Support: http://www.cisco.com/techsupport
> Copyright (c) 1986-2004 by cisco Systems, Inc.
> Compiled Tue 21-Dec-04 17:56 by pwade
> Image text-base: 0x40010EA4, data-base: 0x413E8000
>
> ROM: System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1)
> BOOTLDR: RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
> (fc1)
>
> Router uptime is 30 minutes
> System returned to ROM by reload at 15:30:10 UTC Tue Jan 25 2005
> System image file is "disk1:rsp-k4pv-mz.120-27.S4.bin"
>
> cisco RSP4+ (R5000) processor with 262144K/2072K bytes of memory.
> R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
> Last reset from power-on
> G.703/E1 software, Version 1.0.
> G.703/JT2 software, Version 1.0.
> X.25 software, Version 3.0.0.
> Chassis Interface.
> 1 VIP2 controller (1 FastEthernet).
> 4 VIP4-50 RM5271 controllers (1 FastEthernet)(1 GigabitEthernet)(2
> HSSI)(1 ATM).
> 2 FastEthernet/IEEE 802.3 interface(s)
> 1 GigabitEthernet/IEEE 802.3 interface(s)
> 2 HSSI network interface(s)
> 1 ATM network interface(s)
> 123K bytes of non-volatile configuration memory.
>
> 107520K bytes of ATA PCMCIA card at slot 1 (Sector size 512 bytes).
> 16384K bytes of Flash internal SIMM (Sector size 256K).
>
> Slave in slot 7 is running Cisco Internetwork Operating System Software
> IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
> (fc1)
> Technical Support: http://www.cisco.com/techsupport
> Copyright (c) 1986-2004 by cisco Systems, Inc.
> Compiled Tue 21-Dec-04 17:56 by pwade
> Slave: Loaded from system
> Slave: cisco RSP4+ (R5000) processor with 262144K bytes of memory.
>
> Configuration register is 0x2102
More information about the cisco-nsp
mailing list