[c-nsp] RPR+ on Cisco 7513
Dan Benson
dbenson at swingpad.com
Tue Jan 25 11:10:47 EST 2005
Here is the config, show DIAG and VER. Thanks again for the insight.. //db
Building configuration...
Current configuration : 1363 bytes
!
version 12.0
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
service single-slot-reload-enable
!
hostname Router
!
boot-start-marker
boot system flash disk1:rsp-k4pv-mz.120-27.S4.bin
boot-end-marker
!
redundancy
no keepalive-enable
mode sso
logging snmp-authfail
!
ip subnet-zero
ip cef distributed
ip ssh time-out 120
ip ssh authentication-retries 3
hw-module slot 6 image disk1:rsp-k4pv-mz.120-27.S4.bin
hw-module slot 7 image disk0:rsp-k4pv-mz.120-27.S4.bin
!
!
!
interface GigabitEthernet0/0/0
no ip address
no ip directed-broadcast
load-interval 30
negotiation auto
!
interface FastEthernet1/0/0
no ip address
no ip directed-broadcast
shutdown
!
interface FastEthernet2/0/0
ip address 10.0.6.53 255.255.255.0
no ip directed-broadcast
no ip route-cache cef
no ip route-cache distributed
no ip route-cache
!
interface Hssi3/0/0
no ip address
no ip directed-broadcast
shutdown
!
interface Hssi3/0/1
no ip address
no ip directed-broadcast
shutdown
!
interface ATM4/0/0
no ip address
no ip directed-broadcast
shutdown
no atm enable-ilmi-trap
no atm ilmi-keepalive
!
ip default-gateway 10.0.6.1
ip classless
!
!
!
!
line con 0
line aux 0
line vty 0 4
exec-timeout 0 0
password gnaps123
login
length 0
!
no cns aaa enable
end
Router# sho redundancy
Redundant System Information :
------------------------------
Available system uptime = 28 minutes
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 6
Current Software state = ACTIVE
Uptime in current state = 27 minutes
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 21-Dec-04 17:56 by pwade
BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1;
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 7
Current Software state = STANDBY HOT
Uptime in current state = 0 minutes
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 21-Dec-04 17:56 by pwade
BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1;
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
*
*Router#sho diagbus 6
Slot 6:
EEPROM format version 1
Route/Switch Processor 4, FRU: RSP4+=, HW rev 1.06, board
revision A0
Serial number: 21016486 Part number: 73-5512-02
Test history: 0x14 RMA number: 00-00-00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 1A 01 06 01 40 AF A6 49 15 88 02 14 00 00 00
0x30: 50 FF FF 02 00 00 00 00 00 00 00 00 00 00 00 00
Router#sho diagbus 7
Slot 7:
EEPROM format version 1
Route/Switch Processor 4, FRU: RSP4+=, HW rev 1.06, board
revision A0
Serial number: 28443840 Part number: 73-5512-02
Test history: 0x00 RMA number: 00-00-00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 1A 01 06 01 B2 04 C0 49 15 88 02 00 00 00 00
0x30: 50 00 00 02 00 00 00 00 00 00 00 00 00 00 00 00
Router#
Router#sho ver
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 21-Dec-04 17:56 by pwade
Image text-base: 0x40010EA4, data-base: 0x413E8000
ROM: System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1)
BOOTLDR: RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
(fc1)
Router uptime is 30 minutes
System returned to ROM by reload at 15:30:10 UTC Tue Jan 25 2005
System image file is "disk1:rsp-k4pv-mz.120-27.S4.bin"
cisco RSP4+ (R5000) processor with 262144K/2072K bytes of memory.
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
Last reset from power-on
G.703/E1 software, Version 1.0.
G.703/JT2 software, Version 1.0.
X.25 software, Version 3.0.0.
Chassis Interface.
1 VIP2 controller (1 FastEthernet).
4 VIP4-50 RM5271 controllers (1 FastEthernet)(1 GigabitEthernet)(2
HSSI)(1 ATM).
2 FastEthernet/IEEE 802.3 interface(s)
1 GigabitEthernet/IEEE 802.3 interface(s)
2 HSSI network interface(s)
1 ATM network interface(s)
123K bytes of non-volatile configuration memory.
107520K bytes of ATA PCMCIA card at slot 1 (Sector size 512 bytes).
16384K bytes of Flash internal SIMM (Sector size 256K).
Slave in slot 7 is running Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 21-Dec-04 17:56 by pwade
Slave: Loaded from system
Slave: cisco RSP4+ (R5000) processor with 262144K bytes of memory.
Configuration register is 0x2102
More information about the cisco-nsp
mailing list