[c-nsp] Cisco 3750G-48TS Stacked Switch problems

[Saku Ytti]

On (2005-07-22 13:21 -0500), Robert Holtz wrote:

> Just for clarification: we're using the WS-3750G-48TS-S switches. 
> These are the 1U units that have 48 ports of gb copper and four gb
> fiber uplinks.  There are no additional modules outside of GBICs.
> 
> Ours are also L2 only.  Mainly L2 multicast traffic.
> 
> The only requirement outside of stock ip services is the crypto stuff for SSH.

Even IP Base (SMI) has SSH if k9 image is chosen.

> On 7/22/05, Saku Ytti <saku at ytti.fi> wrote:
> > On (2005-07-22 13:06 -0500), Robert Holtz wrote:
> > 
> > > Cisco is the one which pointed us towards the current image we're using.
> > 
> >  Then they made error. You are running 3750, right? Not the NM-module?
> > If you had used the *.tar files, your 3750 would have said to you, that the
> > platform doesn't support the image.
> > 
> > > Do you have the full IOS image name that you're using?
> > 
> >  Most (>100) of my 3750's are running 12.2(25)SE, but that's already
> > deprecated, those boxes are pure L2. My L3 stacks are running 12.2(25)SEA,
> > as it's first image that had IPv6 support which I need. SEC was released
> > yesterday, and if I had to upgrade any of those today I'd select SEC or
> > SEB2. So:
> > 
> > c3750-advipservicesk9-tar.122-25.SEC.tar (IP Services + IPv6)
> > c3750-ipservicesk9-tar.122-25.SEC.tar    (IP Base + BGP, OSPF, Multicast
> >                                           routing, ECMP routing etc)
> > c3750-ipbasek9-tar.122-25.SEC.tar
> > 
> > 
> > Or SEB2.
> > 
> > --
> >   ++ytti
> >
> 

-- 
  ++ytti