[c-nsp] Router 7206 fails when rebooting

[BoXeR]

Well, my part nbr is 73-6988-11 so it should not be affected (-06 and
earlier are)
Config reg is set to 0x2102 and AUX is not connected.
But it happens sometimes that the console is connected only to router
(second end is hanging) and I have heard, that sometimes it cause
problems with reboot.
Can it be true?
(i am going to make some test with that, but I decided to ask as well) :-)

-- 
Regards
Sebastian


3 marca 2005 (09:43:35)

> Sebastian,

> BoXeR <> wrote on Thursday, March 03, 2005 8:55 AM:

>> Hi everyone,
>> 
>> I am observing that behaviour fopr the last 6 months or longer, but
>> only now I decided to ask you for help.
>> 
>> The problem happens very often (actualy on each reboot) on few routers
>> (probably no rules for that) but the most often I see it on
>> 7206VXR/NPE-G1.
>> 
>> When rebooting, the router almost 100% times jumps into rommon mode.
>> 
>> When I connected a console, the following output was displayed:
>> 
>> *Oct 12 11:03:12.279: %SYS-5-RELOAD: Reload requested by console.
>> Reload Reason: Reload command. monitor: command "boot" aborted due to
>> user interrupt 

> Could your NPE-G1 be affected by
> http://www.cisco.com/warp/public/770/fn28135.shtml? Are any cables
> connected to your AUX port? I assume the config register is set
> correctly (0x2102)..

> 	oli



-- 
[Pozdrawiam] Regards
 BoXeR