[c-nsp] HWIC Card Problem

[Akella Vardhana Srikant]

Folks,

 

I am facing some vague problem with HWIC card which is installed in Cisco 3845 Router. I have mapped one of the Fast Ethernet Port of HWIC to the VLAN Interface for doing Layer 3 Routing.  The problem I am facing is that when I pump traffic to the above mentioned Fast Ethernet Port, it is not getting reflected in the VLAN Interface. To explain in the better way, here is the sample output..........

 

Any guess where could be the problem....

 

interface FastEthernet0/1/0

 switchport access vlan 21

 no ip address

end

 

interface Vlan21

 ip address 192.168.1.1 255.255.255.252

 

chester#  ping 192.168.1.2

 

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms

chester#

 

 

chester#sh int fastEthernet 0/1/0

FastEthernet0/1/0 is up, line protocol is up

  Hardware is Fast Ethernet, address is 0012.dab7.d776 (bia 0012.dab7.d776)

  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Full-duplex, 100Mb/s

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:41, output never, output hang never

  Last clearing of "show interface" counters 00:34:09

  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 64000 bits/sec, 104 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     220839 packets input, 53795012 bytes, 0 no buffer

     Received 1 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

     0 input packets with dribble condition detected

     1085 packets output, 81668 bytes, 0 underruns

     0 output errors, 0 collisions, 2 interface resets

     0 babbles, 0 late collision, 0 deferred

     0 lost carrier, 0 no carrier

     0 output buffer failures, 0 output buffers swapped out

 

 

chester#sh int vlan 21

Vlan21 is up, line protocol is up

  Hardware is EtherSVI, address is 0012.d904.5480 (bia 0012.d904.5480)

  Internet address is 192.168.1.1/30

  MTU 1500 bytes, BW 100000 Kbit, DLY 1000000 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:43, output never, output hang never

  Last clearing of "show interface" counters 00:34:11

  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     38 packets input, 3735 bytes, 0 no buffer

     Received 4 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

     34 packets output, 3657 bytes, 0 underruns

     0 output errors, 0 interface resets

     0 output buffer failures, 0 output buffers swapped out

chester#