[c-nsp] HWIC Card Problem

[MADMAN]

   I doubt it is a problem, just a lack of a feature.

   Dave

Akella Vardhana Srikant wrote:

> Folks,
> 
>  
> 
> I am facing some vague problem with HWIC card which is installed in Cisco 3845 Router. I have mapped one of the Fast Ethernet Port of HWIC to the VLAN Interface for doing Layer 3 Routing.  The problem I am facing is that when I pump traffic to the above mentioned Fast Ethernet Port, it is not getting reflected in the VLAN Interface. To explain in the better way, here is the sample output..........
> 
>  
> 
> Any guess where could be the problem....
> 
>  
> 
> interface FastEthernet0/1/0
> 
>  switchport access vlan 21
> 
>  no ip address
> 
> end
> 
>  
> 
> interface Vlan21
> 
>  ip address 192.168.1.1 255.255.255.252
> 
>  
> 
> chester#  ping 192.168.1.2
> 
>  
> 
> Type escape sequence to abort.
> 
> Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:
> 
> !!!!!
> 
> Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
> 
> chester#
> 
>  
> 
>  
> 
> chester#sh int fastEthernet 0/1/0
> 
> FastEthernet0/1/0 is up, line protocol is up
> 
>   Hardware is Fast Ethernet, address is 0012.dab7.d776 (bia 0012.dab7.d776)
> 
>   MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
> 
>      reliability 255/255, txload 1/255, rxload 1/255
> 
>   Encapsulation ARPA, loopback not set
> 
>   Keepalive set (10 sec)
> 
>   Full-duplex, 100Mb/s
> 
>   ARP type: ARPA, ARP Timeout 04:00:00
> 
>   Last input 00:00:41, output never, output hang never
> 
>   Last clearing of "show interface" counters 00:34:09
> 
>   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
> 
>   Queueing strategy: fifo
> 
>   Output queue: 0/40 (size/max)
> 
>   5 minute input rate 64000 bits/sec, 104 packets/sec
> 
>   5 minute output rate 0 bits/sec, 0 packets/sec
> 
>      220839 packets input, 53795012 bytes, 0 no buffer
> 
>      Received 1 broadcasts, 0 runts, 0 giants, 0 throttles
> 
>      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
> 
>      0 input packets with dribble condition detected
> 
>      1085 packets output, 81668 bytes, 0 underruns
> 
>      0 output errors, 0 collisions, 2 interface resets
> 
>      0 babbles, 0 late collision, 0 deferred
> 
>      0 lost carrier, 0 no carrier
> 
>      0 output buffer failures, 0 output buffers swapped out
> 
>  
> 
>  
> 
> chester#sh int vlan 21
> 
> Vlan21 is up, line protocol is up
> 
>   Hardware is EtherSVI, address is 0012.d904.5480 (bia 0012.d904.5480)
> 
>   Internet address is 192.168.1.1/30
> 
>   MTU 1500 bytes, BW 100000 Kbit, DLY 1000000 usec,
> 
>      reliability 255/255, txload 1/255, rxload 1/255
> 
>   Encapsulation ARPA, loopback not set
> 
>   ARP type: ARPA, ARP Timeout 04:00:00
> 
>   Last input 00:00:43, output never, output hang never
> 
>   Last clearing of "show interface" counters 00:34:11
> 
>   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
> 
>   Queueing strategy: fifo
> 
>   Output queue: 0/40 (size/max)
> 
>   5 minute input rate 0 bits/sec, 0 packets/sec
> 
>   5 minute output rate 0 bits/sec, 0 packets/sec
> 
>      38 packets input, 3735 bytes, 0 no buffer
> 
>      Received 4 broadcasts, 0 runts, 0 giants, 0 throttles
> 
>      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
> 
>      34 packets output, 3657 bytes, 0 underruns
> 
>      0 output errors, 0 interface resets
> 
>      0 output buffer failures, 0 output buffers swapped out
> 
> chester#
> 
>  
> 
>  
> 
>  
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 
> 

-- 
David Madland
CCIE# 2016
Sr. Network Engineer
Qwest Communications
612-664-3367

"Emotion should reflect reason not guide it"