[c-nsp] Weirdness with 2950SX-48-SI

[Adrian Pirciu]

I don't know if it is related, but I just found out that if you press 
the Mode button for 10 seconds (or somehting) the switch will rename 
the startup-config to some other name (forgot which one) and will 
reboot. 

On Friday 22 April 2005 21:35, John Neiberger wrote:
> I just bought a Catalyst 2950SX-48-SI and I think it might be
> acting up. I upgraded the software on it to an image that supports
> SSH and then I configured it. It has been sitting under my desk
> running with no problems for a couple of days. However, this
> morning I went to verify that the config was correct before I
> install it into production later today and I noticed that it was
> sitting at the "switch:" prompt, and subsequent booting showed that
> it had no startup config any longer.
>
> I've since rebuilt the config and all seems to be well, but what
> would cause a switch to reboot to the "switch:" prompt and lose its
> startup config? Very weird...
>
> Thanks,
> John
> --
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

-- 
Adrian