[c-nsp] T3 attenuation cable

[Jan Friedel]

  Hi Gert,

  this is unofficial and untested.

  http://www.cisco.com/en/US/products/hw/modules/ps2033/prod_module_installation_guide09186a00800a85c0.html


  Regards.

--
jf

On Thu, Oct 06, 2005 at 04:27:26PM +0200, Gert Doering wrote:
> Hi,
> 
> we're back to the usual problem - T3 by the local carrier, very short
> cable span, and the signal seems to be too "hot" for the PA-2T3+ we're
> using (if we complain about CRC errors, and they plug their measuring
> equipment between their ADM and our router, the errors are gone...).
> 
> So I think it's time to experiment with attenuation cables, and try
> to reduce the signal a bit, as it might just overdrive the receiver.
> 
> This is where cisco-nsp comes into place: does one of you have a 
> recommendation where to *get* such a cable in Europe, preferrably
> Germany?
> 
> thanks,
> 
> gert
> 
> 
> -- 
> USENET is *not* the non-clickable part of WWW!
>                                                            //www.muc.de/~gert/
> Gert Doering - Munich, Germany                             gert at greenie.muc.de
> fax: +49-89-35655025                        gert at net.informatik.tu-muenchen.de
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/