[c-nsp] MTU on GigE
Vincent De Keyzer
vincent at dekeyzer.net
Wed Oct 19 04:35:51 EDT 2005
Hello again,
I was under the impression that the MTU on a GigE interface was higher than
1500 bytes. Is it true?
If yes, then why does my 7206VXR/NPE-G1 say the following?
GigabitEthernet0/2 is up, line protocol is up
Hardware is BCM1250 Internal MAC, address is 0014.a862.b71a (bia
0014.a862.b71a)
Internet address is x.y.z.198/30
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 2/255, rxload 4/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is SX (.)
Config is
interface GigabitEthernet0/2
ip address x.y.z.198 255.255.255.252
no ip redirects
no ip unreachables
no ip proxy-arp
no ip route-cache cef
no ip route-cache
ip ospf cost 15
duplex full
speed 1000
media-type gbic
negotiation auto
no clns route-cache
end
Vincent
More information about the cisco-nsp
mailing list