[c-nsp] No "ping atm" command in 12.2-xx.Sxx

[Chris Cappuccio]

If you give each customer a separate interface, maybe you could use oam-pvc
manage under pvc x/x?

james edwards [hackerwacker at cybermesa.com] wrote:
> I was hoping to move my DSL agg routers to 12.2S IOS but have discovered 
> there is no "ping atm interface pvc seg/end-loopback" utility in 12.2-18 or 
> 12.2-25, S train. The TAC Software Advisor is confusing on this issue, it 
> lists both "atm ping" and "atm oam ping" which are described as the same 
> thing. It lists "atm oam ping" as only available in 12.0. Searching for "atm 
> ping" yeilds no IOS as matched.I have used it for some time in 12.2T.
> 
> This feature is a must have, it is a quickest way to prove the cross connect 
> is wrong on a DSL circuit or there is a layer 3 problem on any ATM circuit. 
> I do a lot of ATM to FR internetworking an this command is very helpful in 
> troubleshooting the ATM side of a circuit.  Going to 12.3 is not an option. 
> How would I go about getting this command included in 12.2S ?
> 
> James
> Routing and Security Administrator
> At the Santa Fe Office: Cyber Mesa Telecom
> jamesh at cybermesa.com  noc at cybermesa.com
> http://www.cybermesa.com/ContactCM
> (505) 795-7101
> 
> 
> 
>  
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

-- 
"Attacks always get better; they never get worse."
  -- "Old NSA saying"