[c-nsp] PA-2FE-TX using both ports kills module

[Nikolai Schupbach]

Hi Gert,

Gert Doering wrote:

>>If we run this module using a single port everything is stable and fine. 
>>    
>>
>
>Does it work if you run port 1 as "single port"?  Or only "port 0"?
>  
>
It works fine if I use either port, as long as I don't use both ports 
simultaneously.

>All reports seen here in this list that had issues with PA-2FE-TXs have 
>HW rev 1.00 / board revision B0.
>
>We swapped the faulty one in our 7200 to a PA-2FE-TX with revision C0,
>and both ports are working perfectly well now...
>  
>
So it looks like a hardware problem with these revisions? Why is there 
no TAC advisory about this? There must be a lot of cards floating around 
with this problem.

>It would be perfect if you could open a TAC case on this, so this could
>finally be tracked down (we can't right now).
>  
>
I would like to, but I don't currently have a maintenance contract on 
this router.

Regards, Nikolai.