[c-nsp] Enterprise IOS 12.2 default MPLS label protocol

[Eric Kagan]

I loaded 12.2(32) Enterprise since it listed MPLS VPN Support and its on a
Agg router with just T1's so I was trying to reduce some overhead and not
use SP code.  I can't get the MPLS VPN's to talk from this router.  I don't
see a way to change the label protocol (like with SP code below) and can't
find any docs on what the default is (the SP code mentions LDP is the
default but is that true for 12.2 Enterprise) ?   I am assuming that is my
problem at this point.  If I need to upgrade to SP code I can, but have a
few other Agg routers that I would like keep Enterprise running on.

Thanks
Eric

Enterprise router info:

slot0:c7200-js-mz.122-32.bin

#show mpls int
Interface              IP    Tunnel   Operational
FastEthernet0/0        Yes   No       Yes


(config)#int f0/0
(config-if)#mpls ?
  ip           Configure dynamic MPLS forwarding for IP
  mtu          Set tag switching Maximum Transmission Unit
  netflow      Configure Egress Netflow Accounting
  traffic-eng  Configure Traffic Engineering parameters

(config-if)#exit
(config)#mpls ?
  cos-map      Configure MPLS CoS ATM Multi-VC CoS Map
  ip           Dynamic MPLS forwarding for IP
  label        Label properties
  prefix-map   Configure MPLS CoS Tag-VC Multi-VC Prefix Map
  traffic-eng  Configure Traffic Engineering parameters

(config)#mpls label ?
  range  Label range

(config)#mpls label range ?
  <16-1048575>  Minimum label value


---------------------------------------------------


SP Code router:

c7200-p-mz.122-25.S8.bin

#show mpls int
Interface              IP            Tunnel   BGP Static Operational
FastEthernet0/0        Yes (ldp)     No       No  No     Yes


config-if)#mpls label protocol ?
  both  Use LDP or TDP (Adapt to peer on multiaccess interface)
  ldp   Use LDP (default)
  tdp   Use TDP