[c-nsp] Etherchannels and member port load

[Tassos Chatzithomaoglou]

On a 3550 (src-mac) i also get the same:

Index   Load   Port     EC state        No of bits
------+------+------+------------------+-----------
   0     00     Gi0/9    Desirable-Sl       0
   0     00     Gi0/10   Desirable-Sl       0


Tim Stevenson wrote on 9/2/2006 1:11:

> Ah - on 4500, not sure, I only know for 6500... :/  I would think it 
> would be the same, but you'd think that for a lot of Catalyst things... ;)
> 
> Tim
> 
> At 03:01 PM 2/8/2006, Jee Kay submitted:
> 
>>On 08/02/06, Tim Stevenson <tstevens at cisco.com> wrote:
>>
>>
>>>Index   Load   Port     EC state        No of bits
>>>------+------+------+------------------+-----------
>>>   0     55     Gi3/1    On    4
>>>   1     AA     Gi3/2    On    4
>>
>>Any idea why 'load' and 'no of bits' are both 0 for me? Have I been an
>>idiot and forgotten some obvious piece of config?
>>
>>This is on a 4503, running 12.2(25)EWA4.
>>
>>Thanks,
>>Ras
> 
> 
> 
> 
> Tim Stevenson, tstevens at cisco.com
> Routing & Switching CCIE #5561
> Technical Marketing Engineer, Catalyst 6500
> Cisco Systems, http://www.cisco.com
> IP Phone: 408-526-6759
> ********************************************************
> The contents of this message may be *Cisco Confidential*
> and are intended for the specified recipients only.
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 

-- 
***************************************
         Tassos Chatzithomaoglou
Network Design & Development Department
              FORTHnet S.A.
          <achatz at forthnet.gr>
***************************************