[c-nsp] VLAN tagging

[Brian Desmond]

On an access port vlan tagging doesn't occur...
 
 
If you want to convert a trunk port to an access port, the command on cat is 
 
set trunk 3/1 off
set vlan 2 3/1
 
That would turn off trunking on 3/1 and set the port to be a member of vlan2. You may just be able to do only the second command, been quite a while since I was on a CatOS device.
 
Is this what you're looking for or something else?
 
Thanks,
Brian Desmond
brian at briandesmond.com
 
c - 312.731.3132

________________________________

From: cisco-nsp-bounces at puck.nether.net on behalf of Scott Ingram
Sent: Wed 1/11/2006 1:48 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] VLAN tagging



I'm running a 6500 CATos and I want to remove tagging to a specific
port.  Any Ideas?

IMPORTANT NOTICE:

This message is intended only for the use of the individual or entity to which it is addressed and may contain information that is privileged, confidential and exempt from disclosure under applicable law.  If you have received this message in error, you are hereby notified that we do not consent to any reading, dissemination, distribution or copying of this message.  If you have received this communication in error, please notify the sender immediately and destroy the transmitted information.

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/