[c-nsp] configuring access-list on 3550

[Sam Stickland]

I believe the 3550 only shows access-list matches for software switched
traffic. Hardware switched won't update the counters.

Sam

> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-
> bounces at puck.nether.net] On Behalf Of Prit Patel
> Sent: 04 July 2006 14:25
> To: NSP List
> Subject: [c-nsp] configuring access-list on 3550
> 
> hello all,
> 
> I m configuring 3550 with access-list and applied that ACL on one of the
> interface which is configured in routing mode.
> But i m not able to see any match on the acl. Its showing match only on
> permit ip any any statement.
> 
> I m running c3550-i5q3l2-mz.121-22.EA7.bin image on this switch.
> 
> Below is the acl
> access-list 101 deny   tcp any any range 1718 1721
> access-list 101 deny   tcp any any range 5060 5061
> access-list 101 deny   udp any any range 1718 1721
> access-list 101 deny   udp any any range 5060 5061
> access-list 101 permit ip any any
> 
> I have applied it on interface as incoming acl
> 
> Int F0/21
> ip access-group 101 in
> 
> 
> Did i made any mistake in this config ?
> 
> 
> Regards
> Prit
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/