[c-nsp] Catalyst 1924XL Port Rate limiting

[Ge Moua]

I've done this with MDU where you trunk sub-interface with a router on a
stick and you rate limit the route points of the sub-interface.  This setup
uses trunking (.1q or isl) between router and the 1924xl.  Hope this helps.


:-)
Regards,
Ge Moua | Email: moua0100 at umn.edu

Network Design Engineer
University of Minnesota | Networking & Telecommunications Services
2218 University Ave SE | Minneapolis, MN 55414-3029
Office: 612.626.2779 | Pager: 612.###.#### | Fax: 612.626.1818

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Skeeve Stevens
Sent: Tuesday, July 11, 2006 7:17 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Catalyst 1924XL Port Rate limiting


Hey all,

	I know this is an ancient bit of tech, but I am looking at re-using
them in an apartment block with 10 apartments sharing a 1.5mb DSL Link.

	I want to know if it is possible to rate limit the 10mb ports on a
1924XL to say, 256k/256k or 256k/64k each.

	.Skeeve


_______________________________________________________
Skeeve Stevens, RHCE     Email: skeeve at skeeve.org
Website: www.skeeve.org  - Telephone: (0414) 753 383
Address: P.O Box 1035, Epping, NSW, 1710, Australia

eIntellego - skeeve at eintellego.net - www.eintellego.net
_______________________________________________________
I'm a groove licked love child king of the verse
Si vis pacem, para bellum



_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/