[c-nsp] PA-2FE-ISL

[Samit Jana]

Hi all,

I encounter Some weired problem..I have a  Cisco 7204VXR with NPE300, 
C7200-IO-FE , two PA-FE-TX and one PA-4T. After calculation the b/w points , 
I added one additional PA-2FE-ISL . Now as per my expectation,  I should see 
total  5 Fast Ethernet BUT it should only 4 FastEthernet and 1Ethernet.
After power recycling several times finally just for 1 time I saw 5 
FastEthernet in sh ver, but again after reload it was gone and never came 
back thenafter.

 Where did this Ethernet stuffs came from instead of Fast Ethernet ? Any 
idea ? or am I missing something? 


 Below is sh ver and sh diag output :

#############################

cisco-7204-vxr>sh ver
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-P-M), Version 12.2(29), RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 11-May-05 15:38 by kellmill
Image text-base: 0x60008940, data-base: 0x610EA000

ROM: System Bootstrap, Version 12.1(20000824:081033) [dbeazley-cosmos_e_LATEST 
101], DEVELOPMENT SOFTWARE
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(5)T1,  RELEASE SOFTWARE 
(fc1)

cisco-7206-vxr uptime is 3 days, 22 hours, 41 minutes
System returned to ROM by reload at 02:46:07 NST Sat Jun 17 2006
System restarted at 02:47:39 NST Sat Jun 17 2006
System image file is "slot0:c7200-p-mz.122-29.bin"

cisco 7204VXR (NPE300) processor (revision D) with 229376K/65536K bytes of 
memory.
Processor board ID 18286542
R7000 CPU at 262Mhz, Implementation 39, Rev 2.1, 256KB L2, 2048KB L3 Cache
4 slot VXR midplane, Version 2.0

Last reset from power-on
X.25 software, Version 3.0.0.
Bridging software.

PCI bus mb0_mb1 (Slots 0, 1, 3 and 5) has a capacity of 600 bandwidth points.
Current configuration on bus mb0_mb1 has a total of 400 bandwidth points.
This configuration is within the PCI bus capacity and is supported.

PCI bus mb2 (Slots 2, 4, 6) has a capacity of 600 bandwidth points.
Current configuration on bus mb2 has a total of 500 bandwidth points
This configuration is within the PCI bus capacity and is supported.

Please refer to the following document "Cisco 7200 Series Port
Adaptor Hardware Configuration Guidelines" on CCO <www.cisco.com>,
for c7200 bandwidth points oversubscription/usage guidelines.


1 Ethernet/IEEE 802.3 interface(s)
4 FastEthernet/IEEE 802.3 interface(s)
4 Serial network interface(s)
125K bytes of non-volatile configuration memory.

16384K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102

My sh diag:

cisco-7204-vxr>sh diag
Slot 0:
        Fast-ethernet on C7200 I/O card with MII or RJ45 Port adapter, 1 port
        Port adapter is analyzed
        Port adapter insertion time 3d22h ago
        EEPROM contents at hardware discovery:
        Hardware revision 1.4           Board revision A0
        Serial number     15317647      Part number    73-2956-06
        FRU Part Number:  C7200-IO-FE-MII/RJ45=

        Test history      0x0           RMA number     00-00-00
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 83 01 04 00 E9 BA 8F 49 0B 8C 06 00 00 00 00
          0x30: 50 00 00 00 99 09 20 00 00 FF FF FF FF FF FF FF

Slot 1:
        Fast-ethernet (TX-ISL) Port adapter, 1 port
        Port adapter is analyzed
        Port adapter insertion time 3d22h ago
        EEPROM contents at hardware discovery:
        Hardware revision 1.5           Board revision C0
        Serial number     32133951      Part number    73-1688-05
        FRU Part Number:  PA-FE-TX

        Test history      0x0           RMA number     00-00-00
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 11 01 05 01 EA 53 3F 49 06 98 05 00 00 00 00
          0x30: 60 00 00 00 04 04 12 00 FF FF FF FF FF FF FF FF

Slot 2:
        Fastethernet (TX-ISL) Port adapter, 2 ports
        Port adapter is analyzed
        Port adapter insertion time 3d22h ago
        EEPROM contents at hardware discovery:
        Hardware revision 1.2           Board revision B0
        Serial number     10977792      Part number    73-2618-02
        FRU Part Number:  PA-2FE-TX=, PA-2FEISL-TX=

        Test history      0xE           RMA number     00-00-00
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 6C 01 02 00 A7 82 00 49 0A 3A 02 0E 00 00 00
          0x30: 58 00 00 00 98 10 09 00 FF FF FF FF FF FF FF FF

Slot 3:
        Serial Port adapter, 4 ports
        Port adapter is analyzed
        Port adapter insertion time 3d22h ago
        EEPROM contents at hardware discovery:
        Hardware revision 1.0           Board revision A0
        Serial number     3544864       Part number    73-1389-05
        FRU Part Number:  PA-4T=

        Test history      0x0           RMA number     00-00-00
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 04 01 00 00 36 17 20 49 05 6D 05 00 00 00 00
          0x30: 50 00 00 00 00 00 00 00 FF FF FF FF FF FF FF FF

Slot 4:
        Fast-ethernet (TX-ISL) Port adapter, 1 port
        Port adapter is analyzed
        Port adapter insertion time 3d22h ago
        EEPROM contents at hardware discovery:
        Hardware revision 1.0           Board revision A0
        Serial number     4621972       Part number    73-1688-03
        FRU Part Number:  PA-FE-TX

        Test history      0xE           RMA number     14-77-97
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 11 01 00 00 46 86 94 49 06 98 03 0E 0E 4D 61
          0x30: 50 00 00 00 97 01 25 00 FF FF FF FF FF FF FF FF


-- 
samit